705171
15
Zoom out
Zoom in
Vorherige Seite
1/20
Nächste Seite
14
The sound quality changes...
The monitor hisses, hums or makes other loud noises...
Repeat the steps in the Troubleshooting section above before continuing to the next
steps.
Disconnect the signal cable at the input of the monitor. With power on, place your ear
close to each driver (tweeter/woofer) and listen for noise (i.e. a slight hiss or hum).
If there’s absolutely no sound whatsoever, it could be that one or more of the drivers
(woofer, tweeter or both) is at fault. It’s also possible that the problem lies somewhere
in the electronics.
Play some non-distorted source material at a low volume. Carefully cover the tweeter
(to block the sound) without touching the diaphragm. Is the woofer producing a clean
sound? If there is not a clear tonal quality, or any sound at all, then the woofer
probably needs to be replaced.
Cover the woofer so you can hear mostly the tweeter. Is the tweeter producing a clear
sound? If there is not a clear tonal quality, or any sound at all, then the tweeter
probably needs to be replaced.
Once you have a better idea of what may be at fault please call our customer service de
partment. We will help you determine the best solution to correct your monitors. KRK
Customer Service can be reached at 1-800-444-2766, or by email at Service@Gibson.com.
Here are some suggestions that will help you eliminate these undesirables from your
system:
Make sure that the power cord is plugged snugly into the IEC socket on the rear
of the monitor.
Check the connections between the signal source and the monitor. The RoKit G2’s XLR
and TRS connectors are a completely balanced system. If you’re connecting an unbal
anced output to the monitor, be sure that you’re using Pin 2 for signal and have Pin 1
and Pin 3 tied together at the source end.
Refer to the Connecting Your System section on page 6 of this manual to ensure
that the AC mains is matched to the operating voltage requirements.
All audio equipment should use the same ground point. Check all other devices
using the same AC output in the building such as dimmers, neon signs, TV screens, and
computer monitors. These devices should not be using the same circuit.
rokit_manual REV E_rokit_manual 2/19/13 10:24 AM Page 15
15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für KRK Systems Rokit Powered G2 Series wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info