Bedienungsanleitung Krups f 880 (Seite 17 von 36) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

361241

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

To rinse the steam nozzle :

• place a container under it,

• slowly turn the steam tap to the max

position and allow the steam to escape for

about 10 seconds.

• reset the tap to the O position and empty

the container.

Filling the water boiler

• Before using the appliance, check that the

boiler is full of water.

• Place a container under the percolation

head.

• Switch on the appliance and set the pump

switch to the « » position. As soon as

water flows from the percolation head, the

boiler is full.

If the water boiler empties itself during the

preparation of the steam (steam stops coming

out of the evacuation pipe), it must be refilled.

• To do this, turn the steam tap to position O,

place a container under the percolation head

and set the pump switch to the « »

position.

• Allow the water to flow from the

percolation head until the yellow light goes

on ; then reset the pump switch to position

• Wait until the yellow light has gone out

before resuming steam production by slowly

turning the steam tap to the max position.

Preparing an espresso

• Fill the water tank with fresh water (1) (2)

(3).

• Set the pump switch to position

(4).

• Switch on the appliance (5).

• Set the pump switch to the « » position

and wait until a small amount of water flows

out, which means the boiler is full.

• Then reset the pump switch to position

As soon as the system has reached the

required temperature, the yellow light will go

out.

• Preheat the espresso cups, having first

engaged the filter holder (without any

coffee) and place them underneath.

• Set the pump switch to the « » position

(9).

• Fill the cups with boiling water and reset the

pump switch to position

• Remove the filter holder.

• Insert the appropriate fillter (for one or two

cups) into the filter holder (10).

• Fill with one or two measures of ground

coffee (11).

• Press down the coffee with the measuring

spoon (12).

• Remove any coffee from the edges of the

filter holder (13).

• Insert the filter holder and turn it firmly to

the right (14).

• Place one or two espresso cups beneath the

filter holder.

• Prepare the espresso by turning the pump

switch to the « » position (15).

• When a sufficient quantity has run through,

reset the pump switch to position

• After making the espresso, remove the filter

holder and throw away the coffee grounds

(16).

The following espresso may be prepared by

refilling the filter.

Making steam

Steam can be used to make the milk frothy

for a cappuccino or for heating liquids.

The temperature required to produce steam

being higher than that necessary to make an

espresso, the espresso should always be

prepared first, because otherwise the coffee

might be burnt.

The nature of the system is such that a little

water, which can be collected in a separate

container, will escape from the steam nozzle

before the steam appears.

ART. 880.PM6.5 19/01/04, 16:0117

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Krups f 880 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info