Bedienungsanleitung Krups f 897 (Seite 15 von 50) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

361267

Zoom out

Zoom in

Vorherige Seite

1/50

Nächste Seite

• Never immerse the appliance in water.

• Keep out of reach of children and do not

allow the cord to hang down.

• Follow the descaling instructions.

• Do not use the appliance if it is damaged or

if the cord is in poor condition.

• If the cord or any other specific part

becomes defective, these must be replaced

by a Krups approved service centre. You

should never, under any circumstances, open

the appliance yourself.

• Check that the capsule holder is firmly in

place before making coffee.

Accessories

For best results, the appliance is delivered with

a set of accessories.

• 4 Nespresso cups

• 4 varieties of Nespresso coffee (4x10

capsules)

• 1 special hexagonal key (for dismantling the

capsule holder)

• 1 cleaning needle

For further information on the different

varieties of coffee available, or to order

capsules, you should contact your Nespresso

Club. Details on your appliance or in the «

Welcome Pack ».

Setting-up the appliance

• Lift the water tank lid and remove the water

tank (1).

• Fill the water tank with fresh water (2).

Maximum capacity is

1.8 l = about 25 espresso cups.

• Replace the water tank and press down

firmly into position, so that the lower valve

opens (3).

• Close the lid again.

For a good cup of espresso, it is

recommended tha you observe the following

points:

• Empty the water tank after use.

• Change the water every day.

• Do not use mineral water or distilled water.

• Clean the water tank at least once a week.

Before using your espresso

maker for the first time

• Plug in the appliance.

• Introduce the empty capsule holder into the

fixing ring : to do this, position the handle at

about 90° to the left, then thighten up by

pulling the handle firmly to the right (4).

§ Fill the water tank.

• Place a container, large enough, under the

capsule holder and another under the steam

nozzle (5).

• Turn the steam/hot water button to the

position

(6).

• Press the ON/OFF key

, the red operating

indicator light will flash and all the green

indicator lights will come on (7).

Once the red operating indicator light stops

flashing the appliance is ready to be used (8).

• By pressing the key

, the water will run

through the system (9).

• Repeat this operation five times.

• Press the

and turn the steam/hot water

button to the

position (10). Allow about

half a litre of water to run through and then

turn the steam/hot water button to the

position.

Preparation of Espresso

• Fill the water tank (1) (2) (3).

• Preheat the capsule holder, put it in position

on the machine, but without the capsule (4).

• Turn the steam/hot water button to the

position

(6).

• Press the ON/OFF key

, the red operating

light will flash and all the green indicator

lights will come on (7). Once the red

operating light stops flashing the machine is

ready for use (8).

ART. 897.PM6.5 18/02/04, 10:1015

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Krups f 897 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info