Bedienungsanleitung Krups XP 2000 COMBI-APPARAAT (Seite 23 von 43) (Deutsch, Englisch, Holländisch, Französisch)

8987

Zoom out

Zoom in

Vorherige Seite

1/43

Nächste Seite

However, we would advise you to use the

Krups descaling accessory, reference F054,

which is available from Krups after-sales ser-

vice centres. This accessory includes, apart

from two descaling doses, a testing strip for

water hardness to assess the frequency of

descaling of your appliance in normal use.

Descaling depends on the hardness of the

water, but also on the use cycle. The frequently

of descaling indicated by the F054 accessory is

thus given by way of indication only.

- Then follow the following method:

• Remove the Claris-Aqua Filter System

cartridge if you have installed one.

• Unscrew the grid from the brewing head of

the appliance and clean it (21).

• Dissolve a sachet of KRUPS descaling

accessory, reference F054, in half a litre of

lukewarm water and pour the whole lot into

the empty water tank.

• Start the appliance by pressing button (N)

(4). As soon as the appliance reaches the

right temperature, the orange temperature

control light switches off.

• Place a container under the brewing head.

Run through about 1/3 of the liquid

immediately, setting the selector to the

posi-

tion

(9).

• Stop the appliance by pressing button (N) (4)

and leaving the position

(9) engaged

and wait for 10 – 15 minutes to allow the

descaler to take effect.

• Next, start the machine again by pressing

button (N) (4) and allow the rest of the

liquid to run through.

• Then rinse with two water tanks of fresh

water, clean the brewing head and replace

the grid on the head of the appliance

(Consult the “Cleaning the Machine”

section).

Troubleshooting

Problems Probable Corrective

causes actions

Espresso not hot Cups, filter and Preheat the

enough filter holder accessories (cups,

are cold. filter, filter holder)

See paragraph

"Preparing an

espressoé.

Coffee leaks The filter holder See paragraph

around the filter is not mounted "Preparing an

holder correctly or has espresso".

not been tightened

sufficiently.

There are coffee Clean around the

grounds on the filter and the

edge of the filter gasket.

The brewing head Clean the gasket

gasket is dirty. with a damp

cloth.

The brewing Contact an

head gasket approved Krups

is defective. service centre.

Pump is very noisy No water in the Fill the water tank.

water tank.

Water tank incor- Press firmly down

rectly mounted. on the water tank.

Coffee grounds too Use fresh coffee.

old or very dry

and the pump can-

not produce

pressure.

Water does not No water in the Fill the water tank.

run through water tank. Press firmly down

Water tank incor- on the water tank.

rectly mounted.

The filter is blocked, Clean the filter and

the coffee grounds the grid on the

are too fine or head.

tamped down too See the paragraph

hard. "Maintenance"

and try a coarser

coffee.

Brewing head Put the grid to

grid is encrusted soak in descaling

solution

See paragraph

"Maintenance".

Appliance needs See paragraph

descaling. "Descaling".

Water runs Coffee grounds too Try a finer coffee

through too coarse

quickly

XP 2000 anglais.P65 10/01/06, 14:5125

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Krups XP 2000 COMBI-APPARAAT Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Krups XP 2000 COMBI-APPARAAT

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info