Bedienungsanleitung Krups XP5220 (Seite 60 von 120) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch, Norwegisch, Finnisch)

565305

Zoom out

Zoom in

Vorherige Seite

1/120

Nächste Seite

English

PREHEATING THE ACCESSORIES

For the best results, we recommend that you preheat the accessories (filter holder and cups) without

espresso ground coffee. To do so:

n Fill the water tank and turn the machine on. (fig.1, 2, 3 and 4).

n Put the filter holder in place, place the cups below.

As soon as the appliance reaches the required temperature, the light stops flashing.

n Turn the switch to the "coffee" position (fig.8).

n When the cups are filled with hot water, turn the switch to the "off" position. (fig.9).

n Remove the cups.

n Unlock the filter holder: press "OPEN" while turning the filter holder to the left and remove it from the

machine. (fig.10).

Note: When the appliance is hot, the espresso cups can be preheated on the cup warming plate.

WITH GROUND COFFEE

The type of coffee you choose will determine the strength and taste of your espresso. Always

use espresso ground coffee. Do not use instant coffee, cafetiere coffee or filter coffee.

n Fill the water tank and turn the machine on (fig. 1, 2, 3 and 4). During the preheating of the appliance,

the light flashes.

n Using the measuring spoon, place the espresso ground coffee in the filter holder: one spoon (full to the

brim) per cup (fig.5).

n Remove any excess espresso ground coffee from the edge of the filter.

Important: Do not tamp the coffee down in the filter holder. The coffee is automatically

tamped using the KTS “Krups Tamping System”.

n Insert the filter holder in the device by turning it to the right as far as it will go, up to the stop

(fig.7).

n Put one or two cups under the filter holder (fig.8).

As soon as the appliance reaches the required temperature, the light stops flashing.

n Turn the switch to the “coffee” position (fig.8).

n When you have the desired amount of coffee, turn the switch to the "off" position (fig.9).

n Unlock the filter holder: press “OPEN” while turning the filter holder to the left and remove it from the

machine (fig. 10).

n Remove the used espresso coffee grounds using the ejection system by pressing the "EJECT" button

located between the two coffee outlet nozzles (fig.11). Wash the filter holder under running water,

pressing "EJECT" to eliminate the remnants of grounds.

The filter holder now can be filled again to prepare other espressos.

WITH AN “E.S.E." ESPRESSO POD

“ESE” for “Easy Serving Espresso" is a packaged pod (44 mm diameter) of 7g of selected

coffee, ground and compacted between two paper filters, specially designed to make Italian

style ristretto (tight) espressos.

This system allows immediate, simple, clean and comfortable use of your machine.

n Fill the water tank and turn the machine on (fig. 1, 2, 3 and 4). During the pre-heating phase, the

indicator lamp will flash.

n Tear the excess paper off the pod, put the E.S.E. pod in the filter holder, with the red writing facing

down (fig.6).

Be sure to place all the paper inside the filter holder, otherwise there might be leaks.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Krups XP5220 Seite 60

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info