657919
108
Zoom out
Zoom in
Vorherige Seite
1/152
Nächste Seite
17 TUNING THE ENGINE 106
17.4 Carburetor - idle
E00370-10
The idle setting of the carburetor has a big influence on the starting behavior, stable
idling, and the response to throttle opening. This means that an engine with a correctly
set idle speed is easier to start than if the idle speed is set wrongly.
Info
The carburetor and its components are subject to increased wear caused by
engine vibration. Wear can result in malfunctioning.
The factory setting for the carburetor is set for the following values.
(EXC EU/AU, EXC EU, EXC Six Days EU)
Height above sea level 301… 750 m (988… 2,461 ft)
Ambient temperature 16… 24 °C (61… 75 °F)
Super unleaded (95 octane) mixed with 2-stroke engine oil (1:60) ( p. 142)
(300 EXC BR)
Height above sea level 751… 1,500 m (2,464… 4,921 ft)
Ambient temperature 16… 24 °C (61… 75 °F)
Super unleaded, type C (ROZ 95/RON 95/PON 91 mixed with 2-stroke engine
oil, 1:60) ( p. 142)
(All XCW/XCW Six Days models)
Height above sea level 0… 300 m (0… 984 ft)
Ambient temperature 16… 24 °C (61… 75 °F)
Super unleaded (95 octane) mixed with 2-stroke engine oil (1:60) ( p. 142)
The idle speed is adjusted with adjusting screw
.
The idle mixture is adjusted using the idle air adjusting screw
.
17.5 Carburetor adjusting the idle speed
E00370-11
Screw idle air adjusting screw
all the way in.
Turn the idle air adjusting screw to the specified basic setting.
Info
The basic adjustment is shown under the respective model.
Run the engine until warm.
Guideline
Warm-up time 5 min
Danger
Danger of poisoningExhaust gases are toxic and inhaling them may result
in unconsciousness and death.
Always make sure there is sufficient ventilation when running the
engine.
Use an effective exhaust extraction system when starting or running the
engine in an enclosed space.
Adjust the idle speed with adjusting screw
.
Guideline
Choke function deactivated The choke lever is pushed in to the stop. ( p. 17)
Idle speed 1,400… 1,500 rpm
Turn idle air adjusting screw
slowly in a clockwise direction until the idle speed
begins to fall.
Note the position and turn the idle air adjusting screw slowly counterclockwise until
the idle speed again begins to fall.
Adjust to the point between these two positions with the highest idle speed.
108

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für KTM 250 EXC - 2017 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info