Basic settings
Initial Settings
After your steam oven is first plugged in or after a
power failure, the clock display will flash to indicate
that the time shown is not correct.
The oven will not operate until the clock, the water
hardness parameter and the Calibration is set.
To set the clock and the water hardness parameter
value proceed as described in the following chapters.
Setting the clock
The clock display will flash if your appliance is first plugged in or after a power failure, to indicate that the time shown is not
correct. To set the clock, proceed as follows:
To set the clock, proceed as follows:
1. Press the “On/Off” key to switch the oven on.
2. Press the “Time function” key.
3. Press the “–” and “+” keys to select the desired
hour.
4. Press the OK key , to confirm the hours.
5. Press the OK key to confirm the hours. The
minutes digits will flash.
6. Press the “-” and “+” keys to set the minutes.
7. Press the OK key to confirm the minutes.
Water Hardness setting
The appliance features a system that automatically indicates
when it is time to descale.
The system can be optimized for households with very soft
water (also through using a water softening appliance) and
very hard water, by changing the user settings to the
relevant range of water hardness (see table below).
To set the water hardness parameter, proceed as follows:
1. Press the “On/Off” key to switch the oven on.
2. Press the “–” and “+” keys simultaneously
(approximately 1 second). The Water Hardness level
will start to flash on the display.
(Steps 1 and 2 are not necessary if the oven is first
plugged in or after a power failure.)
(If you hold the "-" and "+" keys for about 5 seconds
the appliance will start the descaling process. To
cancel the descaling process, press the “On/Off” .
key).
3. Press the “–” and “+” keys to select the desired
water hardness according to the table below.
4. Press the “OK” key to set the parameter. The
oven returns to the “ON” state.
