Bedienungsanleitung Kyocera CONTAX SL300R T (Seite 11 von 133) (Englisch)

512521

Zoom out

Zoom in

Vorherige Seite

1/133

Nächste Seite

Introduction

• Prolonged use may cause the AC adapter to feel warm; this is a normal phenomenon and not a

malfunction.

• When not using the AC adapter for an extended period of time, first remove the plug from the

camera body, then disconnect the adapter from its AC outlet.

• If you wish to use the AC adapter while batteries are loaded in the camera, first set the camera’s

power switch to OFF, then connect the AC adapter before turning on the camera again.

WARNING

• Be sure that AC adapter plugs are connected securely before use. Loose

plugs and poor contacts can cause generation of heat, fire, and electrical

shock.

• Do not attempt to modify the AC adapter’s cords, or subject them to

unreasonable force. Damage to the cords can cause fires and electrical

shock. If cords become so damaged that their wire cores are exposed,

discontinue use and consult your dealer or Kyocera/Yashica Service Center.

• Do not attempt to remove covers, disassemble, repair or modify AC adapter,

since dangerous electrical shock could result.

• AC adapter plugs that have become laden with dirt or household dust should

not be used or approached with metal objects, since electricity might be

transmitted through the metal, causing fire or personal electrical shock. In the

event of heavy soiling of a plug, remove it from its outlet and clean away the

dirt before reusing.

• In the event that AC adapter plug emits smoke or unusual smell or sound, or

if it is damaged by impact or falling, cease use immediately. Continuing to use

a damaged plug could result in fire danger. In the event of damage to a plug,

consult your dealer or Kyocera/Yashica Service Center.

• Do not connect the AC adapter to any sources of power other than a

household AC outlet (AC 100V to 240V; 50/60Hz). Using the adapter with

other voltages or ratings may cause the hazard of fire or electrical shock.

CAUTION

• Use only the dedicated AC adapter supplied with the digital camera. Using

other adapters may result in accidents and fire danger.

• Never attempt to splice the AC adapter cord, or subject it to severe twisting,

bending, or stretching.

• Do not connect or disconnect the AC adapter with wet hands, since personal

electrical shock could result.

• Always grasp the plug body (not cord) when removing the AC adapter plugs

from camera and power outlet. Pulling on the cords could cause breakage or

other damage to the wires, resulting in danger of fire or electrical shock.

• The AC adapter has been designed for exclusive use with this camera. To

prevent the danger of fire and electrical shock, do not use the adapter with

products other than the specific digital camera for which it was designed.

• If you notice any damage to the AC adapter, including broken wires or faulty

plug connections, stop using the AC adapter and consult your dealer or

Kyocera/Yashica Service Center as soon as possible.

Finecam_E.book Page 11 Thursday, August 28, 2003 6:21 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kyocera CONTAX SL300R T Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info