Bedienungsanleitung La Crosse WS-1516-IT (Seite 13 von 20) (Englisch)

626738

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

Note:

After power up, the time and date and total rainfall are displayed as "- - -". After time is adjusted

manually, the set time will be shown.

SWITCHING ON/OFF THE BUZZER

User may choose to turn off the buzzer so that when the time alarm is switched on and activated,

the buzzer will not sound but we can still see the alarm icon ((())) flashing on the LCD for time

alarm.

On the other hand, when the buzzer is turned off and any weather alarm is activated, the

particular weather digits will flash to show user that the weather condition is being out of the

preset threshold value, yet the buzzer will not sound.

To switch off the buzzer:

1. In normal display mode, press and hold the SET key until the icon "BUZZER OFF" is

shown at the right side above the Wind direction scale. The LCD will change to setting

mode.

2. Press ALARM or HISTORY key once to return to the normal display mode. The "BUZZER

OFF" icon will still be shown.

To re-enable the buzzer:

1. When the BUZZER OFF icon is shown on LCD, press and hold the SET key until the

BUZZER OFF icon disappears.

BUZZER OFF icon

2. Press ALARM or HISTORY key once to return to the normal display mode. The "BUZZER

OFF" icon will no longer be shown. Then the alarm will sound normally.

LOW BATTERY INDICATOR

The low battery indicator of the weather station and the transmitter will be displayed at the top

and bottom portion of the LCD respectively when the battery power is low. It is recommended to

replace the batteries in all units on an annual basis to ensure optimum accuracy of the system.

Note:

 After battery change, both the Weather Station and the transmitters need to be reset (see

note ”Setting up”)

 The History data record will be clear after the battery change.

OUTDOOR TRANSMITTER 915 MHz RECEPTION CHECK

The outdoor temperature, humidity, wind data are transmitted from thermo-hygro transmitter

every 4.5 seconds; the rainfall data are transmitted from the rain sensor every 6.25 seconds. The

receiver will be synchronized to the thermo-hygro transmitter and rain sensor then. The

transmission range (up to about 330 feet /100 meters) of the thermo-hygro transmitter/ rain

sensor may be affected by the ambient temperature. At cold temperatures, the transmitting

distance may be decreased. Please keep this in mind when placing the transmitter and the rain

sensor.

If (1) the outdoor data are not being received within first several minutes after setting up; (2) the

outdoor display always show “- - -“ on the outdoor display; or (3) the reception icon of thermo-

hygro transmitter (Mode 1) and rain sensor (Mode 2) is not displayed on the display, user shall

check the following points:

1. The distance of the Weather Center or transmitter/ rain sensor should be at least 5 to 6.5

feet (1.5 to 2 meters) away from any interfering sources such as computer monitors or TV

sets.

2. Avoid positioning the Weather Center onto or in the immediate proximity of metal doors or

window frames.

3. Using other electrical products such as headphones or speakers operating on the same

signal frequency (915 MHz) may prevent correct signal transmission and reception.

4. Neighbors using electrical devices operating on the 915 MHz signal frequency can also

cause interference.

5. “Visibility” of weather center and transmitters increases the range.

Note:

When the 915 MHz signal is received, do not re-open the battery compartment cover of either the

transmitter/ rain sensor or Weather Center, as the batteries may spring free from the contacts

and force a false reset. Should this happen accidentally then reset all units (see Setting up

above) otherwise transmission problems may occur.

During normal operation, after the outdoor display shows "- - -", the weather center will change to

receive the outdoor data every 15 minutes, until the data is read. Then the reception period for

thermo-hygro transmitter will return to 4.5 seconds (6.25 seconds for rain sensor).

If no reception is possible despite the observation of these factors, all system units have to be

reset (see Setting up).

POSITIONING:

Prior to permanently affixing any of the units, please ensure the following points are considered:

 Cable lengths of the units meet with your distance requirements at the point of fixing

 Signals from the sensors can be received by the base station at points of mounting

The Weather Center

The Weather Center has been designed to be hung onto wall or free standing.

To wall mount

Choose a sheltered place. Avoid direct rain and sunshine.

Before wall mounting, please check that the outdoor values can be received

from the desired locations. To wall mount:

1. Fix a screw (not supplied) into the desired wall, leaving the head

extended out the by about 5mm.

2. Hang the station onto the screw. Remember to ensure that it locks into

place before releasing.

The Thermo-hygro Sensor

An ideal mounting place for the thermo-hygro sensor would be the outer wall beneath the

extension of a roof, as this will protect the sensor from direct sunlight and other extreme weather

conditions.

Rain Cover

Main nit

Wall Bracket

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

La Crosse WS-1516-IT Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info