19
• Within ferro-concrete rooms (basements, superstructures), the received signal is naturally
weakened. In extreme cases, please place the unit close to a window and/ or point its front
or back towards the Frankfurt transmitter.
• During nighttime, the atmospheric disturbances are usually less severe and reception is
possible in most cases. A single daily reception is adequate to keep the accuracy deviation
below 1 second.
TIME ZONE SETTING
After entering the manual setting mode as described above, the time zone can be set between
the 0 to -12 hour and then runs from 12 back to 0 in consecutive 1-hour interval. To do this:
1. The current time zone value starts flashing.
2. Use the + key to set the time zone. The range runs from 0 to -12 and then runs from 12
back to 0 in consecutive 1-hour interval.
3. Press and release the SET key to enter the “Language Setting”.
LANGUAGE SETTING
The weekdays can be displayed in LCD2 with the pre-set languages: German, US English,
French, and Spanish.
1. Set the desired language for the weekday display in LCD 2 by use of the + key.
2. Press and release the SET key to enter the mode “Manual Time Setting”.
MANUAL TIME SETTING
In case the Moonphase wall clock is not able to detect the DCF-signal (disturbances, transmitting
distance, etc.), the time can be manually set. The clock will then work as a normal Quartz clock.
1. The hour digits will start flashing on LCD1.
2. Set the desired hours by pressing and releasing the + key followed by pressing the SET
key.
3. Now the minute digits will start flashing.
4. Set the desired minutes by pressing and releasing the + key . If the + key is held, the units
will increase by 5.
5. Press and release the SET key to move to the “Year Setting”.
YEAR SETTING
The year can be selected sequentially from 2000 to 2049 and will then start over again (default
setting 2001). Only the last 2 digits of the year will be visible on LCD2 .
1. The year digits will start flashing on LCD2. Select the desired year by use of the + key.
2. Press and release the SET key to switch to the “Month Setting”.
