22
OUTDOOR TEMPERATURE TRANSMITTER:
The temperature is measured and transmitted to the Moonphase wall clock every 4 seconds.
The range of the outdoor temperature transmitter may be affected by the temperature. At cold
temperatures the transmitting distance may be decreased. Please bear this in mind when
positioning the transmitter. Also the batteries may be reduced in power during periods of extreme
cold temperatures.
868MHz RECEPTION CHECK FOR OUTDOOR TEMPERATURE TRANSMITTER
The Moonphase wall clock will receive the temperature data within 4 seconds. If the temperature
data is not being received 2 minutes after setting up (or the display shows “- - -”), then please
check the following points:
1. The distance of the Moonphase wall clock or outdoor temperature transmitter should be at
least 2 meters away from any interfering sources such as computer monitors or TV sets.
2. Avoid placing the receiver onto or in the immediate proximity of metal window frames.
3. Using other electrical products such as headphones or speakers operating on the same
signal frequency (868MHz) may prevent correct signal transmission and reception.
4. Neighbors using electrical devices operating on the 868MHz signal frequency can also
cause interference.
Note:
When the 868 MHz signal is received correctly, do not re-open the battery cover of either the
outdoor temperature transmitter or moonphase wall clock, as the batteries may spring free from
the contacts and force a false reset. Should this happen accidentally then reset all units (see
Setting up above) otherwise transmission problems may occur.
The maximum transmission range is 100 meters from the outdoor temperature transmitter to the
moonphase wall clock (in open space). However, this depends on the surrounding environment
and interference levels. If no reception is possible despite the observation of these factors, all
system units have to be reset (see Setting up).
CHANGING THE DISPLAY MODE (DATE, SECONDS, AND TEMPERATURES)
There are four possible display modes to view the day, seconds, and temperatures.
The indoor temperature/outdoor temperature/date/weekday is the default.
To change the display:
1. Press the + key. The display should now show the seconds/outdoor
temperature/date/weekday.
