Step 1 Remove the packaging material and keep it out of the reach of children.
Step 2 Before continuing, make sure that the plug is not inserted in the socket.
Step 3 Remove (8) the plastic screw gland (foot fastening) from the stand (6)
and place the stand (6) in the plastic base (7), this fits through the
design in only one way. Mount the plastic foot (7) firmly to the stand
(6) using (8) the plastic screw fitting (foot mounting).
Step 4 Turn (2) the plastic screw cap (fan blade fastening) of the fan shaft,
paying attention to rotate clockwise to disassemble this screw cap.
(LOOSEN).
Step 5 Turn (4) the plastic screw gland (protective grid fastening) of the motor
housing, counterclockwise to remove this screw gland
Step 6 Place (5) the rear protective grid against the front of the motor housing.
Make sure that the positioning pins on the motor housing are correctly
positioned in the holes in the protective grid.
Step 7 Now tighten (4) the plastic screw gland (protective grid fastening)
tightly clockwise on the thread of the motor housing.
Step 8 Remove the PVC sleeve from the motor shaft.
Step 9 Place (3) the fan blade on the motor shaft. Important! Make sure that
the pins on the motor shaft are correctly positioned in the recesses in
the fan blade.
Step 10 Tighten (2) the plastic screw cap (fan blade attachment) firmly anti-
clockwise on the motor shaft to secure the fan blade.
Step 11 Check that the fan blade rotates properly.
Step 12 Now place (1) the front protective grille (including the pre-assembled
plastic ring) on (5) rear protective grille. Make sure that the rear
protective grid fits into the recesses of the plastic ring. This is easiest
working from top to bottom.
Step 13 Close the transparent locking flap and secure this flap with the supplied
screw.
Step 14 Insert (9) the supplied adapter with the connecting plug fan side into
the plastic base (7).
Step 15 Place 2 pieces AAA batteries (not included) in the remote control.
Step 16 Set the fan to the desired height (length 84 or 109 cm)
Operation
Do not start using the fan until:
- All packaging is removed and places away
from children
- All safety instructions have been observed
- The fan is places on a stable flat surface
Put the fan in the correct position and desired
height.
Insert the plug into a suitable socket. The red
light on the control panel lights up.
Press the ON/OFF button. The red light changes
from red to green, the fan starts to run at the
pre-set speed of about 850 rpm. The speed
button lights up.
