Setting fan speed:
Turn clockwise (+) to increase fan speed and
counterclockwise (-) to decrease fan speed. 24
speeds can be set, from 240 rpm to about 1160 per
minute. (each step is 40 revolutions per minute).
The illuminated ring around the speed knob indicates
the set fan speed. With each two steps of the speed
button, a light lights up more or less. Note that the
speed button can be rotated several times. Note the
illuminated ring to see at what speed the fan is
working.
The "beep" sound on the button operation can be switched off by pressing the
MODE button for 3 seconds on the fan control panel or the SILENT button on the
remote control.
Cleaning and maintenance
Switch the fan off and remove the plug from the socket if you wish to clean the
device or perform maintenance.
The fan only needs general, exterior maintenance. Dust it regularly with a soft cloth
or duster or use a vacuum cleaner with a soft brush to clean. If it is very dirty,
open the grille and clean grilles and blades using a soft, damp cloth and a mild
household cleaning agent. Dry everything thoroughly and allow the fan to dry
properly before reassembling and using again. Ensure that water does not come
into contact with anything other than the grille and blades. Never rinse or spray the
fan!
In order to prevent material discolouration or deformities, never use aggressive or
corrosive (cleaning) products.
If the fan is to be stored at the end of the season, repack in its original packaging:
this offers the best protection. Store it in a safe and dry place that is not subject to
extremes of heat or cold.
Problems and solutions
The fan blades do not rotate even though the device is switched on
Is the plug in the socket?
Is there power to the socket?
Is the blade blocked, e.g. by damage, a deformity on the grille or a foreign
object?
There is strange noise when starting
Check to ensure the blades are placed as far over the motor axle as possible.
Check if there are any burrs around the edges of the blades.
Check whether the blades have become deformed and are touching the
protective grille.
