Bedienungsanleitung Leica S (Seite 48 von 78) (Englisch)

585256

Zoom out

Zoom in

Vorherige Seite

1/78

Nächste Seite

SHUTTER SPEED PRIORITY - T

Setting the mode

1. Set the shutter speed dial (1.11) to the desired exposure time.

2. Press the click wheel (1.18) to set automatic exposure control, i.e. in

this case shutter speed priority mode.

The lens aperture is then controlled automatically based on the available

light and continuously between a fully open and minimum aperture for

the relevant lens.

The viewﬁnder and top panel display show

• T (shutter speed priority) for the selected exposure mode (2.3.c/3.8)

• the automatically controlled aperture value (2.4/3.11)

• the manually set shutter speed value (2.2a/3.12)

Notes:

• If automatic sensitivity setting is activated at the same time (see p. 34),

the control range for shutter speed priority is extended.

By contrast, any maximum shutter speed set as part of the automatic

sensitivity setting is ineffective.

• With very little light or extreme brightness, the available aperture range

of the lens you are using may no longer be sufﬁcient for the selected

exposure time. Set a different shutter speed if possible. However, a cor-

rect exposure is normally still achieved in such cases, by automatic set-

ting of the appropriate shutter speed, i.e. by "overriding" your manual

selection. (2.2b) may appear as a warning message to indicate that

you are below the metering range (see p. 41). It is then no longer possi-

ble to correctly meter the exposure.

• If the shutter speed dial is set to (=1/125s) the camera switches to M

(see next section). As soon as a different shutter speed is set, it switch-

es back to T.

MANUAL APERTURE AND SHUTTER SPEED

SETTING - M

Setting the mode

1. Set the shutter speed dial (1.11) to the desired value.

2. Press the click wheel (1.18) to set manual exposure control , i.e. in this

case manual mode.

3. Turn the click wheel (1.18) to set the desired aperture.

The viewﬁnder and top panel display show

• M for the selected exposure mode (2.3.d/3.8),

• the manually set aperture (2.4/3.11) and shutter speed values

(2.2a/3.12), and

• a light balance (2.6), which assists in adjusting the exposure.

The light balance shows the deviation of the set shutter speed/aperture

combination from the metered exposure value. The display clearly shows

the range ±3 EV in 1/2 EV steps. Larger deviations are shown by ﬂashing

of the outer markings on the light balance.

To achieve the correct exposure according to the result of the exposure

metering, the aperture and/or shutter speed should be adjusted until

the zero marking lights up on the light balance.

Notes:

• If automatic sensitivity setting is activated at the same time (see p. 34),

the last manually set sensitivity is used.

• Any maximum shutter speed set as part of the automatic sensitivity set-

ting has no effect.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Leica S Seite 48

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Leica S

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info