GB 7
CD SECTION
Channels: 2 channels
S / N ratio: 60 dB
Wow & Flutter: undetectable
Samplingfrequency: 44.1kHz8xoversampling
Quantization: 16 bits DA converter
Pickuplightsource: Semi-conductorlaser
Pickupwavelength 790nm
RADIO SECTION
Tuningranges: FM87.5-108MHz
AM 522 - 1620 kHz
Antennas: AM Built - in ferrite bar
FM Wire antenna
GENERAL
Output power: 2 W + 2 W
Power consumption: 17 WATTS
Speaker: 3"8OHM
Phones jack: 3.5MM
Power source: AC : 230V ~ 50Hz
Dimensions
Main Unit: 175 (L) x 207 (D) x 133 (H)mm
Speaker: 110 (L) x 174 (D) x 133 (H)mm
Remote control: 35 (L) x 18 (D) x 190 (H)mm
Weight: 2.63Kgs
Duetocontinuingimprovement,thefeaturesandthedesignaresubjecttochangewithoutnotice.
Where to place the item :
Today’sfurnitureiscoatedwithawidevarietyoflacquersandsynthetic-coatingsthataretreatedwithanextensiverange
ofcleaningproducts.Therefore,thepossibilitythatsomeofthesesubstancescontaincomponentsthatreactadverselyto
the rubber feet of the item and soften them, cannot be completely excluded. The rubber feet of the appliance can cause
discoloringtofurnituresurfaces.Ifnecessary,placetheapplianceonanon-slidesurface.
If at any time in the future you should need to dispose of this product please note that Waste
electrical products should not be disposed of with household waste.Please recycle where
facilitiesexist.CheckwithyourLocalAuthorityorretailerforrecyclingadvice.
(WasteElectricalandElectronicEquipmentDirective)
SPECIFICATIONS
CLEANING CD
If the CD skips or will not play , the disc may
needcleaning.Beforeplaying,wipethedisc
fromthecentreoutwithacleaningcloth.After
playing,storethediscinitscase.
MAINTENANCE
CLEANING THE UNIT
Donotusevolatilechemicalsonthisunit.Cleanbylightly
wipingwithasoftcloth.
IMPORTANT NOTE
Ifanabnormaldisplayindicationoranoperatingproblem
occurs, disconnect the AC power cord. Wait at least 5 seconds,
then reconnect the AC power cord.
WARNING
ShouldtheCDdoorbeopenedbeforethereadingoftheCD
completed,ajammingnoisemayoccur.Thisisresolvedby
closingtheCDdoor.
CLEANING THE CD LENS
If the CD lens is dusty, clean it with a brush-blower. Blow
several times on the lens and remove the dust with the brush.
Fingerprints may be removedwith acotton swabmoistened
with alcohol.
For information and support, www.lenco.eu