804852
8
Zoom out
Zoom in
Vorherige Seite
1/14
Nächste Seite
4.7 Connecting the appliance
NOTICE
Failure to connect properly
Damage to the electronics.
uDo not connect the appliance to a stand-alone inverter, e.g.
solar power systems and petrol generators.
uDo not use an energy saving plug.
WARNING
Failure to connect properly
Fire hazard.
uDo not use an extension cable.
uDo not use distributor blocks.
The type of current (alternating current) and voltage at the
installation site have to conform with the data on the type plate
(see 1 Appliance at a glance) .
The socket must be properly earthed and fused. The tripping
current for the fuse must be between 10 A and 16 A.
The socket must be easily accessible so that the appliance can
be quickly disconnected from the supply in an emergency. It
must be outside the area of the rear of the appliance.
uCheck the electrical connection.
uPlug in the power plug.
4.8 Switching on the appliance
Put the appliance into operation about 2 hours before first
loading food to be frozen.*
uTurn the temperature control
Fig. 3 (1)
to the right, from the 0
setting to point 3.
wThe interior light is on.
5 Control
5.1 Refrigerator compartment
The natural circulation of air in the refrigerator compartment
results in zones differing in temperature. It is coldest directly
above the vegetable drawers and at the rear wall. It is warmest
at the top front of the compartment and in the door.
5.1.1 Refrigerating food
The coldest areas are directly above the vegetable compart-
ments and along the back wall. The warmest area is at the top
front and in the door.*
uStore perishable foods such as ready-to-eat meals, meat
and sausages in the coldest area. Place butter and
preserves in the top area and in the door. (see 1 Appliance
at a glance)
uUse reuseable plastic, metal, aluminium, glass containers
and foil wrap to store food.
uAlways store raw meat and fish in clean, sealed containers
on the bottom shelf of the refrigerator, to prevent them
coming into contact with or dripping onto other foods.
uFoods that easily absorb or give off smell or taste, as well as
liquids, should be stored in sealed containers or covered.
uDo not pack foods too closely together, as the air needs to
circulate.
5.1.2 Setting the temperature
The temperature can be set between 1 (warmest temperature,
minimum cooling performance) and 7 (coldest temperature,
maximum cooling performance).
The middle control setting is recommended, then a middle
temperature of approx.5 °C is established in the refrigerator
compartment.
An average temperature of approx. –18 °C is then established
in the freezer compartment.*
To ensure ideal temperatures for storing frozen foods, a setting
of “4” to “7” on the temperature controller is recommended.
Selecting “7” makes it possible to achieve temperatures under
0 °C in the coldest part of the fridge compartment.*
uTurn the temperature control
Fig. 3 (1)
.
The temperature depends on the following factors:
- the door opening frequency
- how long the door is open for
- the room temperature at the site where the appliance is
installed
- the type, temperature and quantity of frozen food
uAdjust the temperature as needed, using the control.
5.1.3 CoolPlus function*
At low room temperatures of 15 °C or lower:
uPress the Cool-Plus switch
Fig. 3 (2)
.
wThe deep temperatures in the freezer compartment are
ensured.
Once the room temperature is again higher than 15 °C :
uDeactivate the Cool-Plus
Fig. 3 (2)
switch manually.
Note
uAt normal room temperatures, in excess of 15 °C, the Cool-
Plus switch should be turned off, as it is not required.
5.1.4 Shelves
Moving or removing shelves
The shelves are prevented from being pulled out accidentally
by pull out stops.
Fig. 11
uLift the shelf and pull forward a little.
uAdjust the height of the shelf. To do this move the slots along
the supports.
uIn order to remove the shelf fully, place it at a slant and pull
out towards the front.
uInsert shelf with the raised edge pointing upwards at the
back.
wThe food does not freeze onto the rear wall.
Dismantling shelves
uThe shelves can be
dismantled for cleaning.
Control
8 * Depending on model and options
8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Liebherr RBstd 528i wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Liebherr RBstd 528i

Liebherr RBstd 528i Bedienungsanleitung - Deutsch - 30 seiten

Liebherr RBstd 528i Bedienungsanleitung - Holländisch - 30 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info