Bedienungsanleitung Liebherr SBSes7273 (Seite 13 von 16) (Englisch)

57026

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

6.3 Cleaning the appliance

CAUTION

Risk of injury and damage as a result of hot steam!

Hot steam may damage the surfaces and cause burns.

uDo not use any steam cleaners!

NOTICE

Incorrect cleaning damages the appliance!

uDo not use cleaning agents in concentrated form.

uDo not use any scouring or abrasive sponges or steel wool.

uPlease do not use any aggressive, scouring, sand-,

chloride-, chemical- or acid-based cleaning agents.

uDo not use chemical solvents.

uDo not damage or remove the type plate on the inside of the

appliance. It is important for the customer service.

uDo not pull off, bend or damage cables or other compo-

nents.

uDo not allow any cleaning water to enter the drain channel,

ventilation grille or electrical parts.

uPlease use soft cleaning cloths and a universal pH-neutral

cleaning agent.

uPlease use cleaning and care products suitable for contact

with foodstuffs in the appliance interior.

uEmpty appliance.

uPull out the power plug.

uClean plastic outer and inner surfaces with lukewarm

water and a little washing-up liquid.

Do not apply stainless steel cleaning agent to glass or plastic

surfaces to prevent them from being scratched. Darker areas at

the beginning and quite an intensive colour of the stainless

steel surface are normal.

NOTICE

The stainless steel doors are provided with a high-quality

surface coating and must not be treated using the accompa-

nying care product.

Otherwise the surface coating will be affected.

uWipe the coated door surfaces using a soft, clean cloth

only. In case of stubborn dirt, use a little water or a neutral

cleaning agent. A microfibre cloth can be optionally used.

uIf the stainless steel side walls are dirty, clean them using

a commercially available stainless steel cleaning agent.

Then evenly apply the accompanying stainless steel care

product, making strokes in the direction of the grain.

uWipe side walls with a paint finish using a soft, clean

cloth only. In case of stubborn dirt, use a little water or a

neutral cleaning agent. A microfibre cloth can be optionally

used.

uClean items of equipment by hand with lukewarm water

and a little washing-up liquid.

uTo dismantle the shelves: remove trims and side parts.

uTo dismantle door racks: Pull off

protective film from the decorative

trims.

uRemove boxes and covers by lifting

up and out.

After cleaning:

uWipe dry the appliance and items of equipment.

uConnect the appliance and switch it on again.

uSwitch on SuperFrost (see 5.8.4) .

When the temperature is sufficiently cold:

uPut the food back inside.

6.4 Cleaning the IceMaker

The drawer of the IceMaker has to be emptied and slid in.

uTo activate the setting mode: press the SuperFrost button

Fig. 2 (3)

for about 5 s.

wThe display indicates c.

wThe menu symbol

Fig. 2 (17)

shines.

uUsing the Up setting button, freezer compartment

Fig. 2 (5)

Down setting button, freezer compartment

Fig. 2 (4)

select I.

uTo confirm: press the SuperFrost button

Fig. 2 (3)

uUsing the Up setting button,

freezer compartment

Fig. 2 (5)

/ Down setting

button, freezer compartment

Fig. 2 (4)

select Ic.

uTo confirm: press the Super-

Frost button

Fig. 2 (3)

wThe IceMaker moves into the cleaning position and switches

off.

uTo deactivate the setting mode: press the On/Off button,

freezer compartment

Fig. 2 (1)

-or-

uWait for 2 minutes.

wThe temperature is indicated again in the temperature

display.

uRemove the drawer.

uClean the ice cube tray and drawer with warm water. If

necessary, use mild washing-up liquid. Then rinse.

uSlide in the drawer again.

If washing-up liquid was used:

uthrow away the first three loads of ice cubes to get rid of any

remaining washing-up liquid.

Either leave the IceMaker switched off in this position or switch

the IceMaker on again (see 5.8.11) .

6.5 Cleaning the dispensing unit

uClean the dispensing unit with a damp cloth.

uClean the ice chute with water and a little washing-up liquid.

uClean drip plate in the dishwasher.

uUse a cloth or sponge to absorb the water in the collecting

trough under the drip plate.

uRemove the ice storage

container with the door in

an open position and

clean with water and a

little washing-up liquid.

uAfter cleaning, slide in the

container again as far as it

will go. If the container will

not slide in all the way,

turn the feed screw

Fig. 9 (1)

Fig. 9

Maintenance

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Liebherr SBSes7273 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Liebherr SBSes7273

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info