Installation
-
It’s recommended at least 2 or more people install the fireplace.
-
Do not switch the appliance on until it properly installed as described in this manual.
-
Do not place the electric fire directly on carpets. This to avoid possible discolouring caused by
the heat or blockage of air inlets.
-
The electric fireplace should be located close to a suitable mains socket to enable connection. The
electrical socket must be easily accessible to allow disconnection.
-
Installation:
Tools Required
A screw driver will be needed.
Locating the Appliance
Your new electric fireplace may be installed virtually anywhere in your home. However, when choosing a location
ensure that the general instructions are followed.
5.1 For best results, install out of direct sunlight.
5.2 The appliance should be connected to an earthed electrical outlet and it must
be easily accessible to allow
disconnection.
Installing the Appliance
5.3 Take out side decorative brackets and ST4×8 screws, fix the side decorative
brackets in the correct position
as shown below paying attention to the direction.
5.4 Install insert from the back of Classic mantel, use 4pcs ST4×12 screws to fix
insert to mantel.
