742180
11
Zoom out
Zoom in
Vorherige Seite
1/24
Nächste Seite
ENG-5
Operating instructions
This appliance can be operated by both remote control and manual button. Once the unit has been
properly connected to an earthed electrical outlet, turn on the main switch located in front of the
appliance. A beep should be heard when the power is rst applied.
Operating by Manual Button
- Manual on/off switch: The power switch supplies power to all of the functions of the replace.
This switch must be in the ‘on’ position for any of the functions including the remote to work.
- Flame button: By pressing the ame effect button the unit will cycle through three ames.
- Heater button: Press once Heater button left hand heater on. Press again turns left hand heater off
and right hand heater on.
Press third time turns left and right hand heater off. There are 3 levels you can cycle through
including the off setting.
- Thermostat setting: 1-9 Step, room temperature is around 9-34 °C, room temperature is too high,
please turn the thermostat knob counter-clockwise direction. If you need to turn on the heater, you
can turn the thermostat knob clockwise direction.
Note: It is possible that if the room temperature is higher than the thermostat setting it will
not come into operation and the heater will remain off until the temperature of the room
cools.
Operating by Remote Handset
- Make sure the battery is installed properly in the remote control.
- The effective range of the remote control is up to 4 meters or 13 feet.
- Power On/Off button: The Power button will put the replace in a standby mode. This will turn off
all functions at once but will hold the settings in memory.
Except Heater function, by pressing the button again the unit will turn on at the same settings.
- Flame effect button: The re has three ame effects, by pressing the ame effect button the
unit will cycle through each effect.
- High button: Press once turns Fan on, 8s later High heat on. Press again turns heat off. 8s later fan
off.
- Low button: Press once turns Fan on, and 8s later Low heat on. Press again turns heat off. 8s later
Fan off.
To Reset the Heater
The appliance is tted with an protection system. The heater includes a protection system that shuts off the
heater if it overheats for any reason:
- Turn unit to off.
- Unplug unit wait 5 minutes.
- Plug in and turn on.
- Remote control functions
In order to protect the product not becoming too hot, there is 8s delay when turning on the heater,
also there is 8s delay when turning off the heater fan.
Receiver
Main power
switch
Flame
button
Heater
button
Thermostat
knob
11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Livin Flame Zurich wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info