27
To select Pressure Type:
1. Press
MENU twice, select NMEA 2000 or NETWORKING and press ENTER. A
menu will appear with five options: Bus Setup, Fuel Management,
NMEA 2000 Alarms, Waypoint Sharing and Backlight
Synchronization.
2. Highlight
BUS SETUP and press ENTER, which will open the Bus
Configuration menu. A list of network devices will be at the top of the
page.
3. Select the desired pressure sensor and press
ENTER. The Device
Configuration menu will appear.
4. Highlight
PRESSURE TYPE and press ENTER. The following
configuration options will appear: Pitot Speed, Boost, Oil, Water, Fuel,
Transmission Oil, Atmospheric and the default setting, Unknown.
5. Highlight the desired Pressure Type and press
ENTER. The following
confirmation message will appear: Are you sure you wish to change this
device's configuration?
6. Highlight
YES and press ENTER. Press EXIT repeatedly to return to
the main display.
NOTE:
You can unconfigure your EP-90R by setting the Location and
Pressure Type to Unknown. You also can use the Restore Defaults
command.
Restore Defaults
The Restore Defaults command will reset your pressure sensor to
default settings.
To restore default settings:
1. Press
MENU twice, select NMEA 2000 or NETWORKING and press ENTER.
A menu will appear with five options: Bus Setup, Fuel Management,
NMEA 2000 Alarms, Waypoint Sharing and Backlight
Synchronization.
2. Highlight
BUS SETUP and press ENTER, which will open the Bus
Configuration menu. A list of network devices will be at the top of the
page.
3. Select the desired pressure sensor and press
ENTER. The Device
Configuration menu will appear.
4. Highlight
ADVANCED OPTIONS and press ENTER.
5. Select
RESTORE DEFAULTS and press ENTER. The following message will
appear: Are you sure you wish to change this device's configuration?
