450947

Maclaren Techno XLR Seite 12

12
Zoom out
Zoom in
Vorherige Seite
1/18
Nächste Seite
3
Instructions
  
 
1 TO OPEN THE BUGGY
A Release storage clip.
B Open out the buggy.
C Using foot, push the footplate down fully to engage the primary lock.
CAUTION: Ensure that all locking devices are engaged before use.
2 TO OPERATE BRAKES
A TO ENGAGE BRAKES: With foot, pull the brake levers fully back.
B TO RELEASE BRAKES: Push the brake levers fully forward.
CAUTION: Parking device shall be engaged during the loading and unloading of children.
CAUTION: Ensure parking device is engaged before leaving the buggy unattended.
3 TO OPERATE FRONT WHEEL SWIVEL LOCKS
A TOLOCKSWIVELS:LiftBOTHswivellockinglevers.
B TOUNLOCKSWIVELS:PushdownBOTHswivellockinglevers.
4 SEAT BELT/SHOULDER HARNESS OPERATION
WARNING: AVOID SERIOUS
INJURY FROM FALLING OR SLIDING OUT.
ALWAYS USE THE CROTCH STRAP IN
COMBINATION WITH THE WAIST BELT AND
SHOULDER STRAPS.
TOFITHARNESS:
A Pull shoulder straps over the childs shoulder then attach to the waist clips by
sliding strap loops onto the hooks.
B Insertbothwaistclipsintotheclasp,shoulderstrapsaresecuredoncetheclipsare
fastened.
C Adjust strap lengths by sliding buckles. Belt and harness should be snug.
TORELEASEHARNESS:
D Press the button on both the front and back of the clasp simultaneously to release.
5 TO FIT HEAD HUGGERS
Unclip shoulder straps from seat belt clasp and feed straps through holes
in head hugger fabric (height can be adjusted by selecting upper or lower holes).
Reclip shoulder straps to seat belt clasp.
TOFITHARNESSPADS
A Lay open pad under shoulder harness strap.
B FoldpadoverandsecureVelcro®strips.
6 TO ATTACH THE SEAT LINER
A Unclip all shoulder and waist straps.
B Feed crotch strap, waist straps and shoulder harness straps through
holes in liner.
C FastentheVelcro®tothebackoftheseat
Reverse this procedure to remove the seat liner for washing
Follow the washing instructions on the care label attached to the seat liner.
Dry thoroughly before retting to the buggy.
The buggy will fold with the seat liner in place.
7 TO OPERATE THE ADJUSTABLE LEGREST
A Raise leg rest.
B Push in the lever on the leg rest to lock.
C To release, simply pull the lever back on base of adjustable leg and allow
the leg rest to return.
8 TO ADJUST SEAT RECLINE
A TORECLINETHESEAT:Positionyourhandontheseatreclinelever.Gentlyliftthe
recline lever with your ngers whilst taking the weight of the seat back with your
hand. Still maintaining support and holding the lever, gently recline the seat back in
to the desired position. Release seat recline lever when seat back is in desired
position, ensuring both sides lock at the same time.
B
TORAISESEATBACK:Fromrearofbuggypushseatbacktooriginaluprightor
desired intermediate position.
9 TO ADJUST HANDLE LENGTHS
A Press triggers.
B Slide handles until triggers locate in one of 3 positions. Release triggers to lock.
10 TO ATTACH THE HOOD
CAUTION: Overloading may cause a hazardous unstable condition to exist.
Maximum total capacity of hood pockets - 1.1 lb (0.5 kg).
A With buggy open clip the hood to the handle tubes just above the retaining blocks.
B WrapVelcro®stripsaroundhandletubes.
C Place rear apron behind seat back
D Extend hood and press down on side hinges to lock open.
TOTILTHOOD:
E Fully unzip back panel.
F Tilt hood forward.
G The hood is removed by rmly pressing down the clip release tabs.
11 TO FIT THE RAIN APRON
A Return hood to non-tilted position before tting rain apron.
B Ensure visor is folded away beneath the hood.
C Place the apron over the hood front.
D Attach two eyelets (one each side) to the hood clips.
E Attach the two eyelets (one each side) to the front legs.
12 TO FIT THE SHOPPING BAG
CAUTION: Overloading may cause a hazardous unstable condition to exist.
Maximum load 4.4 lb (2 kg) evenly distributed.
The buggy may be folded with the bag still attached but all contents must be removed.
Failure to do this could damage buggy and contents of shopping bag.
A Place bag on the ‘X’ frame under seat with lowest edge of bag at front.
B Attach front straps to front legs just below seat.
C Attach rear straps to rear legs just above horizontal tie bar.
13 TO FOLD THE BUGGY
Ensure visor is folded away beneath the hood.
Ensure the seat back is in its fullest upright position and the hood (if tted) is folded
back. Remove contents of shopping bag.
Itisrecommendedthattheharnessisfastenedbeforefoldingthebuggy.
A Using foot, lift up on footplate to release primary lock.
B Push down on secondary lock lever.
C Grip handles and push forward.
D Compress folded buggy and engage the storage clip.
14 REMOVING AND REFITTING THE SEAT COVER
Remove hood, shoulder pads and seat retention straps from buggy if tted.
A Twist shoulder strap end buckles and feed through holes.
B
The waist harness back strap is fixed to the chassis behind the seat.
To remove, twist the buckles on each end of the harness back strap and
unthread from the ‘D’ rings attached to the chassis.
IMPORTANT–Itisimportantthatthestrapberethreadedthroughthe‘D’
rings after the seat has been refitted. Failure to do so will endanger your child.
C Feed crotch strap buckle through holes.
D Unclip seat cover retaining straps.
E Unfasten seat fabric from handle tubes and seat base.
F Slide fabric from seat back and base.
G When retting seat fabric, insert seat back support tubes into fabric ap.
H Whenrettingshoulderstrapschoosethefabricholesappropriatetothechild’s
size. Twist the buckles and feed through seat cover, seat back and then through
holes in plastic seat back arms.
J When retting seat fabric to seat base pass crotch strap buckle through the
hole in the seat fabric and then hole in seat base.
EN
… 12 …

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Maclaren Techno XLR wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Maclaren Techno XLR

Maclaren Techno XLR Bedienungsanleitung - Alle Sprachen - 73 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info