534675
97
Zoom out
Zoom in
Vorherige Seite
1/116
Nächste Seite
97FILAMENT
TROUBLESHOOTING
PLA FILAMENT
Extruder clogs: PLA is hard, dense, and has
a low coecient of friction, which means
that it’s slippery and it can be dicult for
the drive gear inside your extruders to grip. If
there is not enough tension on the bearing
holding the filament against the drive gear,
the teeth of the gear will not bite into the
filament, but will scrape against it, stripping
the filament. If you think you need to increase
the tension on the bearing, contact MakerBot
Support for advice.
PLA is also sensitive to heat. At temperatures
above 55° C, objects made from PLA will
start to get so enough that they might
deform if force is applied to them. At
temperatures of above 150° C, objects
made from PLA might start to lose their
shape. PLA filament should not be heated
to temperatures above 250° C because the
plastic will start to break down.
If plastic stops extruding partway through your
PLA prints, it is probably because the plastic is
overheating. Try lowering extrusion temperature,
removing the enclosure lid, and opening the
door of the MakerBot Replicator 2X.
PLA, or Polylactic Acid, is a biodegradable plastic with features that make it great for 3D
printing -- it doesn’t give o bad-smelling fumes and it has a low rate of thermal expansion,
so it doesn’t warp very much.
PLA is harder and slightly brittle. It is more likely to snap than bend, but that does not mean
that PLA is easily breakable. PLA also stays flexible for a short while as it cools.
97

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für MakerBot Replicator 2X wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info