Bedienungsanleitung Makita AC320H (Seite 8 von 228) (Alle Sprachen)

598387

Zoom out

Zoom in

Vorherige Seite

1/228

Nächste Seite

least 0.3 m away from the wall or other obstructions that

would interfere with the flow of air. The compressor head

and shroud are designed to allow for proper cooling. If

humidity is high, an air filter can be installed on the air

outlet adapter to remove excessive moisture. Place the air

compressor on a level surface so that it rests securely on

the rubber feet. Follow the instructions packaged with the

air filter for proper installation.

LUBRICATION

This air compressor is equipped with an Oil-Less pump

designed for durability and no maintenance.

Power supply

Operate the compressor at voltage specified on the

nameplate. If using the compressor at a higher voltage

than the rated, it will result in abnormally fast motor speed

and may damage the unit and burn out the motor. Also if

using the compressor at a low voltage, it will result in

abnormally slow motor speed and may overheat and shut

off the motor.

Extension Cords

To avoid voltage drop, power loss, and overheating of the

motor, use extra air hose instead of an extension cord.

Low voltage can cause damage to the motor.

If an extension cord must be used;

• Make sure the extension cord is in good condition.

Please see the chart below for MINIMUM extension cord gauge requirement:

Piping

This air compressor is not designed for use with piping.

Never use compressed air with any kind of piping

connected.

DANGER:

Improper grounding can result in electrical shock. Do not

modify the plug that has been provided. If it does not fit

the available outlet, the correct outlet should be installed

by a qualified electrician.

OPERATING PROCEDURES

Daily Start-up Checklist

CONNECTING HOSES

WARNING:

Risk of unsafe operation. Firmly grasp hose in hand

when installing or disconnecting to prevent hose

whip.

Losing control of the hose may result in personal

injury and property damage.

1. Before attaching air hose or accessories, make sure

the switch is set to OFF “O” and drain valve is opened,

the air regulator or shut-off valve is closed. Ensure

compressor is disconnected from the main supply.

2. Attach hose and accessories. Too much air pressure

causes a hazardous risk of bursting. Check the

manufacture’s maximum pressure rating for air tools

and accessories. The regulator outlet pressure must

never exceed the maximum pressure rating.

3. Connect a plug to the outlet.

4. Start the compressor with turning the switch to ON “|”.

Select a operation mode by mode select switch. Close

the drain valve. Motor will stop when tank pressure

reaches “cut-off” pressure.

5. Open the regulator by turning it clockwise. Adjust the

regulator to the correct pressure setting. Your

compressor is ready for use.

6. Always operate the air compressor in well-ventilated

areas; free of gasoline or solvent vapors. Do not

operate the compressor near the spray areas.

Operating mode

This compressor has a 4 type of operation modes. You

are able to select the available operation mode from 4

functions.

Operating Procedures

You are able to select the available operation mode by

push the mode select switch one time as follow, and

return a starting mode by push the mode select switch

4times.

Amp Rating Range (220 - 240V) Total Length of Cord in Meter

10 m

25 ft.

15 m

50 ft.

20 m

75 ft.

30 m

100 ft.

50 m

150 ft.

60 m

200 ft.

0 - 5 A 1.5 mm

1.5 mm

2.5 mm

4 mm

5.1 - 8 A 1.5 mm

1.5 mm

2.5 mm

4 mm

8 - 12 A 2.5 mm

2.5 mm

4 mm

Not Recommended

Operation

Mode

LED Indication Pressure

MAX Motor

RPM

Rated current

Blue Red CUT-IN CUT-OUT

3.1 - 3.5 MPa

7.0 A

Lights out Lighting 3.1 MPa 3.5 MPa 2,500 min

-1

7 A

2.7 - 3.5 MPa

7.0 A

Lighting Lights out 2.7 MPa 3.5 MPa 2,500 min

-1

7 A

3.1 - 3.5 MPa

5.5 A

Lights out On and off light 3.1 MPa 3.5 MPa 1,800 min

-1

5.5 A

2.7 - 3.5 MPa

5.5 A

On and off light Lights out 2.7 MPa 3.5 MPa 1,800 min

-1

5.5 A

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Makita AC320H Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Makita AC320H

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info