Bedienungsanleitung Makita bsr 730 (Seite 8 von 88) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

382504

Zoom out

Zoom in

Vorherige Seite

1/88

Nächste Seite

OPERATING INSTRUCTIONS

Installing or removing battery cartridge

(Fig. 8)

•

Always switch off the tool before insertion or

removal of the battery cartridge.

•

To remove the battery cartridge, withdraw it from the

tool while sliding the button on the side of the

cartridge.

•

To insert the battery cartridge, align the tongue on

the battery cartridge with the groove in the housing

and slip it into place. Always insert it all the way until

it locks in place with a little click. If you can see the

red part on the upper side of the button, it is not

locked completely. Insert it fully until the red part

cannot be seen. If not, it may accidentally fall out of

the tool, causing injury to you or someone around

you.

•

Do not use force when inserting the battery car-

tridge. If the cartridge does not slide in easily, it is

not being inserted correctly.

Charging (Fig. 9)

1. Plug the battery charger into your power source. Two charging lights will flash in green color repeatedly.

2. Insert the battery cartridge into charger until it stops adjusting to the guide of charger. Terminal cover of

charger can be opened with inserting and closed with pulling out the battery cartridge.

3. When the battery cartridge is inserted, the charging light color will change from green to red and charging

will begin. The charging light will keep lighting up lit steadily during charging.

One red charging light indicates charged condition in 0 – 80% and two red ones indicates 80 – 100%.

4. With finish of charge, the charging lights will change from two red ones to two green ones.

The charging time is as follows:

Battery B2417: approx. 30 minutes.

Battery B2430: approx. 60 minutes.

5. If you leave the battery cartridge in the charger after the charging cycle is complete, the charger will switch

into its ‘‘trickle charge (maintenance charge)’’ mode which will last approximately 24 hours.

6. After charging, unplug the charger from the power source.

Battery type Capacity (mAh) Number of cells

B2417 1,700 20

B2430 3,000 20

Cooling system

•

This charger is equipped with cooling fan for heated battery in order to enable the battery to prove its own

performance. Sound of cooling air comes out during cooling, which means no trouble on the charger.

•

Yellow light will flash for warning in the following cases.

– Trouble on cooling fan

– Incomplete cool down of battery, such as, being clogged with dust

The battery can be charged in spite of the yellow warning light. But the charging time will be longer than usual

in this case.

Check the sound of cooling fan, vent on the charger and battery, which can be sometime clogged with dust.

•

The cooling system is in order although no sound of cooling fan comes out, if the yellow warning light will not

flash.

•

Always keep clean the vent on charger and battery for cooling.

•

The products should be sent to repair or maintenance, if the yellow warning light will frequently flash.

BSR730 (E) (’100. 3. 22)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Makita bsr 730 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Makita bsr 730

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info