Bedienungsanleitung Makita DCL282F (Seite 11 von 84) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Türkisch)

690517

Zoom out

Zoom in

Vorherige Seite

1/84

Nächste Seite

11 ENGLISH

Indicating the remaining battery

capacity

Only for battery cartridges with the indicator

► Fig.3: 1. Indicator lamps 2. Check button

Press the check button on the battery cartridge to indi-

cate the remaining battery capacity. The indicator lamps

light up for a few seconds.

Indicator lamps Remaining

capacity

Lighted Off Blinking

75% to 100%

50% to 75%

25% to 50%

0% to 25%

Charge the

battery.

The battery

may have

malfunctioned.

NOTE: Depending on the conditions of use and the

ambient temperature, the indication may differ slightly

from the actual capacity.

Switch action

► Fig.4: 1. ON/speed change button 2. OFF button

To start the cleaner, simply push the ON/speed change

button. To switch off, push the OFF button.

You can change the cleaner speed in three steps by

pushing the ON/speed change button.

The rst push on this button is for high speed mode, the

second push for max speed mode and the third push for

normal speed mode. Each push on this button repeats

the high/max/normal speed cycle alternatively.

Lighting up the lamp

CAUTION: Do not look in the light or see the

source of light directly.

To turn on the lamp, push the ON/speed change button.

Push the OFF button to turn off the lamp. During the

tool actuating, the lamp turns on.

When the remaining battery capacity gets low, the lamp

starts blinking.

► Fig.5: 1. ON/speed change button 2. OFF button

3. Lamp

NOTE: The timing, at which the lamp starts blinking,

depends on the temperature at work place and the

battery cartridge conditions.

ASSEMBLY

CAUTION: Always be sure that the tool is

switched off and the battery cartridge is removed

before carrying out any work on the tool.

Dust bag and paper lter

Install either dust bag or paper lter before using cleaner.

Use the dust stopper when installing either dust bag or paper lter.

Dust bag are usable many times repeatedly by cleaning it out.

Paper lter is a throw-away type. Throw away the entire

paper lter without emptying when it has become full.

NOTICE: To prevent dust from getting into the

motor:

• Make sure that the dust bag or paper lter is

installed before use.

• Insert the dust stopper together with the

dust bag or paper lter all the way into the

slots when installing them.

• Do not use a broken or ripped bag.

Otherwise the motor may be broken.

NOTICE: Do not fold the cardboard at its open-

ing when installing the paper lter.

NOTICE: Never throw away the dust stopper

because it needs to be used repeatedly whenever

either the dust bag or the paper lter is used.

NOTICE: The paper lter for the cleaner is an

important component for maintaining the tool

performance. Using other than the genuine paper

lter may cause smokes or ignition.

NOTE: When the dust bag or the paper lter is not

installed in the cleaner, the front cover does not close

completely.

► Fig.6

Installing dust bag

Use the dust stopper when installing dust bag. Be

careful not to take the upper side for the lower side by

mistake because they are different each other.

► Fig.7: 1. Upper side of dust stopper 2. Lower side of

dust stopper

1. Insert the protrusion of the dust bag into the lower

groove on the dust stopper as shown in the gure.

► Fig.8: 1. Dust stopper 2. Lower groove 3. Dust bag

There is no distinction between the upper and

lower sides of the dust bag. You may insert its protrusion

of either side into the lower groove of the dust stopper.

► Fig.9: 1. Lower groove

3. Overlap the frame of dust stopper with that of the

dust bag.

► Fig.10

4. Place the dust stopper and the dust bag together

into the cleaner cavity in the same direction of arrow on

the dust stopper. Insert them all the way into the slots in

the cleaner cavity.

► Fig.11

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Makita DCL282F Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info