Operating Instructions, Comfort 580 GB (#91636) 27
7. Hand transmitter
Advice:
For multi-channel hand transmitters,
the coding procedure has to be carried
out for each button separately.
• Actuate the master transmitter and hold the button.
The transmitter LED lights up.
• Whilst keeping the button on the master transmitter
depressed, press the desired button on the other
hand transmitter.
The LED flashes.
After 1 -2 seconds, the LED on the newly programmed
transmitter lights up permanently.
The programming procedure is complete.
The coding of the master transmitter has now been
transferred to the other hand transmitter.
• Remove the transmission plug.
7.2.1 / 2
7.2.1 / 3
7.2.2 Change coding
If a hand transmitter has been lost, this function can
be used to change the coding of the remaining remote
control transmitters.
• Connect one end of the transmission plug to the
hand transmitter.
• At the free end of the transmission plug, short-circuit
one of the outer pins with the centre pin adjacent to
it (e.g. using a screw driver).
• Press the desired button on the hand transmitter.
A new code is then generated by the integrated
random coding facility.
The LED flashes quickly.
As soon as the LED lights up permanently, the hand
transmitter has been programmed with a new code.
The button can then be released and the transmission
plug removed.
Advice:
After the hand transmitter has been
re-programmed, the operator system
must also be re-programmed to
respond to the new code.
For multi-channel transmitters, the
programming process must be carried
out for each button separately.
7.2.2 / 1
