Bedienungsanleitung Mastercraft X14v (Seite 254 von 285) (Englisch)

614259

254

Zoom out

Zoom in

Vorherige Seite

1/285

Nächste Seite

while on the road. Be sure to back in and

completely wet the trailer bunks, then pull

forward to the loading position.

Be certain all the boat tie-downs are

properly fastened down before departing

from the launching ramp area. Proper load-

ing depth on trailers will vary with condi-

tions, but a good starting point would be

the same as launch depth or slightly higher.

Helpfultip: After the launch depth has

been properly determined, apply a strip of

reective tape at the water level on each

guide post. That will allow launch depth to

be easily repeatable.

Wet brakes may not hold and/or may cause

brakes to have diminished performance

characteristics. A few braking applications

at a slow speed will help to dry them out.

Extra care must be used when braking afer

brakes have become wet.

Towing Requirements

States and municipalities may require

special permits and licenses based on the

size and weight of your trailer. Some states

require additional equipment for the tow

vehicle, such as side and rear-view mirrors.

Inquire at your local motor vehicle admin-

istration ofce to nd out what require-

ments affect you.

If you plan to travel in another state, don’t

forget to check requirements there also. In

addition to licenses and permits, there may

be weight, height and width limits for using

certain roads, bridges and tunnels. Also, be

aware of restrictions regarding the transport

of gases or fuels in tunnels.

And don’t forget to contact your insur-

ance company to make sure you have prop-

er coverage for all types of towing situa-

tions. Some jurisdictions may also require

liability insurance. If you have a loan for

the trailer purchase, your lender may also

require insurance.

Trailer Checklist

Before towing the vehicle, be sure to

read and familiarize yourself with the in-

structions and warnings supplied with it.

NEVER TOW THIS VEHICLE BEFORE

YOU CHECK TO BE SURE:

• Coupler, hitch and hitch ball are of the

same size;

• Coupler and safety chains are safely se-

cured to the hitch of the tow vehicle;

• All fasteners are properly tightened;

• Boat is securely tied down to trailer

(winch line is not a tie down);

• Wheel lug nuts are properly tightened;

• Wheel bearings are properly adjusted

and maintained;

• Load is within the maximum load carry-

ing capacity;

• Load inside the boat is properly distrib-

uted;

• Tires are properly inated;

• All trailer lighting is working properly.

• Trailer brakes are properly adjusted and

working (if trailer is so equipped).

• That the tower on the boat (if so

equipped) is secure, whether it is upright

and locked in place or has been lowered.

Also be certain that there is sufcient

overhead clearance before removing the

boat/trailer from cover, or when tow-

ing that the unit will clear any overhead

items such as trees, bridges, overhead

power lines, overpasses, etc.

This trailer is manufactured to meet the

applicable federal safety standards at the

MasterCraft Trailers • 2014 MasterCraft Owners Manual Page 7-29

M A S T E R C R A F T T R A I L E R S

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mastercraft X14v Seite 254

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info