Bedienungsanleitung Mastercraft X30 (Seite 222 von 285) (Englisch)

614263

222

Zoom out

Zoom in

Vorherige Seite

1/285

Nächste Seite

 It is desirable to keep the fuel’s tem-

peraturebelow80F.(26C.)Thegumming

will increase as temperatures increase.

 NotethatfuelstabilizersworkONLYin

freshgasoline.Stabilizerswillnotcureoxy-

genated gasoline. Adding a stabilizer when

the boat is being prepared for outings after

storage will NOT clean the gumming that

has occurred or remove water from the fuel

tank or otherwise eliminate any problems

thathaveoccurredduetofailuretoproperly

preparethefuelingsystemforstorage.

Engine manufacturers suggest using

Federal or State of California reformulated

gasoline whenever possible as it stores as

well or better than conventional gasoline.

Even quality gasoline that has been

properly prepared for storage should

never be stored for a period to exceed

one (1) year.

Fuel systems on all boats MUST be properly

prepared for storage periods exceeding two

(2) weeks, as outlined in this Owner’s Manu-

al. Failure to do so will void the warranty.

General Power Package Preparation

Step 1: Lubricate the throttle and shift

linkages and cables with multi-

purpose grease.

Step 2: MasterCraft recommends that

batteries be removed from the

boatforwinterstorage.Batteries

shouldbefullychargedbeforebe-

ingstoredinacool,drylocation,

protected from the elements and

fully re-chargedbefore being re-

installed in the boat. Never store

batteries close to heat, spark or

ame-producing devices.

Step 3: Leave the engine box cover

propped open about two inches

(2”) to ventilate the engine com-

partment.

Other Winterization Preparations

Step 1: Removethe bilge drain plugim-

mediatelyaftertakingtheboatout

of the water. After a general bow-

to-stern washing, raise the bow

of the boat higher than the stern

to allow as much water as possi-

ble to drain from the bilge, while

performing other storage prepara-

tions.

Step 2: Thoroughly clean the hull, deck

and interior of the boat as soon

as it is removed from the water.

Cleaning at this time is easier be-

cause any marine growth is still

wet.Besuretoallowafewdays

of air drying to prevent mildew

that results from trapped mois-

ture. (See the Cleaning section of

this Owners Manual.)

Step 3: Applyacoatofwaxtotheentire

surface of the boat. We suggest

MasterCraft Premium Marine

Wax for excellent coverage.

Step 4: Iftheboatisequippedwithaheat-

er, shower or ballast bags/tanks,

be sure to disconnect the hoses

anddrainanyremainingwaterin

the lines to avoid freezing. Even

smallamountsofwaterinanyof

these areas can cause signicant

damage upon freezing, and such

damage is not covered under the

warranty!

Care and Maintenance • 2014 MasterCraft Owners Manual Page 6-29

C A R E A N D M A I N T E N A N C E

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mastercraft X30 Seite 222

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info