Bedienungsanleitung Mastercraft X30 (Seite 224 von 285) (Englisch)

614263

224

Zoom out

Zoom in

Vorherige Seite

1/285

Nächste Seite

Care and Maintenance • 2014 MasterCraft Owners Manual Page 6-31

C A R E A N D M A I N T E N A N C E

Re-Activating the Boat After Storage

Step 1: Removetheducttapefromtheex-

haustaps.

Step 2: Fully charge the battery and in-

stall it in the boat, following all

safetyprecautionsassociatedwith

changing batteries.

IMPORTANT NOTE: Often, batteries

that have been stored over winter will re-

quire re-charging. If the battery is charged

by utilizing a battery charger, use only a

three-stage or more battery charger. It is

important that the operator never turn a

battery charger immediately to “start,” as

the sudden jolt of voltage may cause dam-

age to the electrical system, particularly

control modules for ballast system. Regard-

less of whether it is during the re-activation

process or at any time, care should also be

used in charging the battery.

Step 3: Follow all instructions for reacti-

vating the drive train as detailed

in the engine owner’s manual.

NOTE: Due to the complex na-

ture of the reactivation process,

MasterCraft recommends having

an authorized MasterCraft dealer

perform this function.

Step 4: Ensure that all drain plugs

throughout the boat and drive train

have been reinstalled to avoid un-

wanted intrusion of water.

Step 5: Ifapplicable,reconnectthehoses

toyourheaterorshower.

Step 6: Check the engine compartment

and bilge for signs of nesting ani-

mals.Cleanasnecessary.

Step 7: Check the entire engine system

for uid, oil and coolant levels.

Addasnecessary.

Step 8: Check the entire engine for cracks

orleakscausedbyfreezedamage.

Step 9: Check all hose clamps for tight-

ness. Install the bilge drain plug

and the rear drain plug in boats

equipped with certain types of

ballastsystems.

Step 10:Grease the propeller shaft taper

and install the propeller.

Step 11: Fully re-chargeand re-install the

batteryorbatteries.

Step 12:Performthedailymaintenanceas

noted previously in this Owner’s

Manual.Ifitwasnotdonepriorto

storage, perform the annual main-

tenance as well.

Step 13:If the boat is equipped with the

optional fresh water cooling sys-

tem and was drained for storage,

llthe systemwith freshcoolant

solution per instructions.

Step 14: Check the alignment between the

outputangeonthetransmission

and the propeller shaft ange. If

the maximum feeler gauge that

canclipbetweentheangefaces

at any point is 0.003”, the unit

is properly aligned. If a thicker

gaugecanbeinsertedatanypoint,

the engine must be re-adjusted un-

til proper alignment is obtained.

This should be performed by an

authorized MasterCraft deal-

er’s service department.

Step 15: For all models, with the boat in the

water,cyclethekeyONandthen

OFF two (2) or three (3) times, al-

lowingten(10)secondsbetween

key cycles, before cranking

the engine. This allows the fuel

pumptoprimethefuellines;then

starttheengine.Intheeventthe

engine does not respond, allow

a two-minute cool-down period

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mastercraft X30 Seite 224

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info