Bedienungsanleitung Maxdata platinum 3200 i (Seite 15 von 45) (Englisch)

171513

Zoom out

Zoom in

Vorherige Seite

1/45

Nächste Seite

15MAXDATA Server PLATINUM 3200 I M6

3 Setting up the Chassis

This chapter describes how to set up your server chassis for the first time.

Tools and Supplies Needed

• Phillips (cross head) screwdriver (#2 bit)

• Small flat-head screwdriver

• Anti-static wrist strap (recommended)

Safety: Before You Remove the Access Cover

Before removing the access cover for any reason, observe these safety guidelines:

• Turn off all peripheral devices connected to the server.

• Turn off the server by pressing the power button on the front of the chassis. Then unplug the

AC power cord(s) from the chassis or wall outlet.

• Label and disconnect all peripheral cables and all telecommunication lines connected to I/O

connectors or ports on the back of the chassis.

• Provide some electrostatic discharge (ESD) protection by wearing an antistatic wrist strap

attached to chassis ground – any unpainted metal surface – when handling components.

Warnings and Cautions

These warnings and cautions apply whenever you remove the access cover(s) to access components

inside the server. Only a technically qualified person should integrate and configure the server.

WARNINGS

The power button on the front panel DOES NOT turn off the AC power. To remove power from server,

you must unplug the AC power cord(s) from the wall outlet or the chassis.

Hazardous electrical conditions may be present on power, telephone, and communication cables.

Turn off the server and disconnect the power cord(s), telecommunications systems, networks, and

modems attached to the server before opening it. Otherwise, personal injury or equipment damage

can result.

Hazardous voltage, current, and energy levels are present inside the power supply. There are no user-

serviceable parts inside it; servicing should be done by technically qualified personnel.

CAUTIONS

ESD can damage disk drives, boards, and other parts. Perform all procedures in this chapter only at

an ESD workstation. If one is not available, provide some ESD protection by wearing an antistatic

wrist strap attached to chassis ground – any unpainted metal surface – on your server when handling

parts.

Always handle boards carefully. They can be extremely sensitive to ESD. Hold boards only by their

edges. Do not touch the connector contacts. After removing a board from its protective wrapper or

from the server, place the board component side up on a grounded, static free surface. If you place

the server board on a conductive surface, the battery leads may short out. If they do, this will result

in a loss of CMOS data and will drain the battery. Use a conductive foam pad if available. Do not slide

board over any surface.

For proper cooling and airflow, always install the access cover before turning on the server. Operating

it without the cover in place can damage system parts.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Maxdata platinum 3200 i Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info