Bedienungsanleitung Maxima VN-500 (Seite 33 von 35) (Englisch, Holländisch)

785086

Zoom out

Zoom in

Vorherige Seite

1/35

Nächste Seite

 The machine must be connected by a certified electrician. A 1x16A fuse and 30mA

current leakage fuse should be used at a maximum height of 170cm for the 230v

machine. For the 400v machine you should use a 3x16A fuse.

 The protective film on the machine must be removed first after installing the

machine.

 The power supply cable (5x2.5 mm2 H07 RNF), water supply connection (3/4) and

water drain hose come with the machine

 Where the machine is installed, at a height of 25/75cm there should be a ½ water

supply with ¾ valve for the fresh water inlet of the machine. At a height of about

2cm there should be a drain pipe in the wall or ground where the machine is placed.

When using the VN500 Ultra this may be put higher (Max 70CM).

 A ventilation system with cooker hood should be present where the machine is

installed. The user must ensure that the control and electricity in the machine

remains free from moisture, condensation and vapour.

 The leveling feet are height-adjustable. They should be adjusted according to the

ground floor and entry and exit stands, allowing the machine to operate in a leveled

position.

 The manufacturer will not take responsibility for any damage or problems to the

machine or other machines, caused by other machines that are connected to the

same power board, supplying power to the machine. For this reason we advise you

to use a separate group/board for the machine.

Troubleshooting

1. Is the power supply connected properly and are the cables still good and not worn?

2. Does the machine have power? Is the fuse undamaged?

3. Is the cover closed properly?

4. Is the waterhose still connected to the valve and the machine? Is the water valve

opened? Is the hose still good and not worn?

5. Are the detergent and/or rinsing pumps still working and is there still enough in the

supply cans?

6. Are the detergent and rinsing hoses placed in the cans properly? And is there still

enough in both supply cans?

The earth installation for the power supply work, must be constructed

complying with the effective grounding regulations and must be evidenced

by certificates issued by relevant authorities. The service personnel who will

install the machine need to ground the machine with a cable connected to

the power supply, and connected to thegrounding end of the machine cable.

Only after this is done the water connections should be done and then the

machine can be operated. Make sure that all safety regulations are taken

into account while installing the machine. The manufacturer/importer and

dealer will not be responsible for any injuries, damage or other

consequences caused by not following the safety regulations.

Caution: Do not start or use the machine without connecting it to the

earth cable first.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Maxima VN-500 Seite 33

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info