Bedienungsanleitung Maxima VN-500 (Seite 34 von 35) (Englisch, Holländisch)

785086

Zoom out

Zoom in

Vorherige Seite

1/35

Nächste Seite

When all questions can be answered with yes, read the information below for

troubleshooting tips. When these steps do not solve your problems, please contact your

dealer for a certified and authorized service technician.

 The dishwasher is still not cleaning properly.

- Check page 30, 31 & 32 of the manual for the maintenance section and carry out

the maintenance. Thoroughly clean the machine and make sure the pipes and

houses are not blocked and the filters are completely clean.

- If this does not help, you can remove the panel below the door. Behind the panel

are two black knobs. The left knob should be turned to 60 degrees. The right one

should be turned to 85 degrees. If these are lower you have been washing with

water that is to cold, and you should adjust them to 60 and 85.

- In the VN500 Ultra machine there are also the rinse and detergent pumps behind

this panel. With the white screw on the detergent pump, and the copper screw on

the rinsing pump you can adjust the dosage of added substances. Do not add to

much or there will be to much foam and it might spill out of the machine. It is also

possible that the used detergent isn’t strong enough, we advise to use our own

trademark, Maxima. For information on detergent types in your specific situation

you can contact Qlean-tec. They are experts when it comes to cleaning products.

- If this still does not solve the problem and the machine is making a noise, please

contact a certified and authorized service technician and inform him of the problem.

 The water is not draining but I did remove the drain pipe inside the filter.

- If you are using the regular VN500 you have to make sure the drain hose is flat, or

running in a downward angle, and is not kinked. This will block the water from

draining because the regular VN500 has no drain pump. When using the VN500

Ultra and the water will not drain, check wether the drain hose isn’t bend/kinked in a

weird angle. This can also result in the water being blocked.

- In both cases if nothing helps remove the hose from the drain pipe and put it flat on

the floor (in a bucket or flat tile is fine as well as long as the hose is not going up).

As soon as the water starts to drain you can place the hose back in the drain pipe

and try to drain the machine again.

Terms of warranty:

1. Warranty documents without sales date, factory name, and sales company approval

on them are not valid. In order to benefit from the warranty, a warrantydocument

should be presented.

2. After the machine has been installed and operated according to the instructions and

maintenance of the user manual, it is warranted for technicial failures which is

caused by the machine itself. The wearing down of the parts of the machine

however, is not covered.

3. The failures within the scope of warranty, and how and where these will be

resolved, will be determined by Spangenberg International B.V.

4. The warranty is only valid if all the warranty terms, installation instruction and

maintenance instructions in the user manual are fully met and complied with. The

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Maxima VN-500 Seite 34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info