PELLET STOVES Chapter 4
INSTALLATION AND USE MANUAL
page 30
Operation Technical service - Rights reserved MCZ S.p.A. - Reproduction prohibited
Since the remote control acts as an external thermostat, it is
necessary to for the remote control and the stove to
communicate with each other. It is therefore suggested to
keep it in the same room as the stove, within a radius of 8
metres, but not so close that it will be affected by the heat
from the stove.
It is advisable to keep the remote control in the room
where the stove is installed so that the stove and
remote control can communicate with each other.
If the remote control is moved out of range from the
stove, the stove will no longer have any temperature
feedback. It will therefore continue operating in the
same manner as was set by the last transmission
from the remote control.
4.8.3.1.
Changing from automatic to manual mode
To change from MANUAL to AUTOMATIC mode, press button 4 so
that the remote control display shows the message MAN and the bars
for the adjustment of flame power.
4.8.4. Automatic mode with ECO-STOP
This mode changes stove operation in automatic mode. Upon
reaching the temperature set by the user, the stove goes to power 1
for a short period of time. Then, if the temperature remains constant
and above the set temperature, it shuts down. The stove comes back
on automatically only when the room requires heat again, but not
before a period of time has passed for the stove to cool off. This option
is advisable only if the stove works in highly insulated rooms or where
there is low heat dispersion over time.
Example of operation in ECOSTOP mode
If the room temperature detected by the sensor of the remote control
is 15°C and the set temperature is 20°C, the stove will follow a pre-
established ramp up to the 5
th
power. Once 20°C is reached, it goes
into standby mode. When the room temperature drops below the value
set on the remote control (for example 18°C) and a sufficient shutdown
time has elapsed, the stove will come back on automatically and
continue running until again reaching 20°C. If the temperature read by
the sensor in the remote control remains above the value set on the
thermostat (for example 20-21°C) the stove will remain off.
In this mode, lighting can be carried out by the user by resetting the
thermostat temperature to a value greater than that in the room, or by
shutting down the stove by pressing button 3 for a few seconds and
then pressing the same button to re-light the stove.
The “ECO STOP” mode does not need to be reset as it remains in
memory from the last use.
4
