Bedienungsanleitung Medisana BU 550 CONNECT (Seite 27 von 36) (Deutsch, Englisch)

550248

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

WARNING - BATTERY SAFETY INFORMATION

• Only replace with batteries of the same type, never use different types of

batteries together or used batteries with new ones!

• Insert the batteries correctly, observing the polarity!

• Remove the batteries from the device if it is not going to be used for an

extended period!

• Keep batteries out of children's reach!

• Do not attempt to recharge these batteries! There is a danger of

explosion!

• Do not short circuit! There is a danger of explosion!

• Do not throw into a fire! There is a danger of explosion!

• Do not throw used batteries into the household refuse; put them in a

hazardous waste container or take them to a battery collection point, at

the shop where they were purchased!

3.2 Using a Mains Adaptor

Alternatively, you can use the unit with a special mains adaptor (MEDISANA Art.-No.

51013. This connects to the socket provided at the back of the unit. In this case

the batteries remain in the unit. Inserting the connector into the back of the blood pres-

sure monitor switches the batteries off mechanically. It is necessary, therefore, to plug

the mains adaptor into the mains socket first of all and then to connect it to the blood

pressure monitor. If the blood pressure monitor is no longer being used, first remove

the connector from the blood pressure monitor and then pull the mains adaptor out of

the mains socket. Doing this means that the date and time will not have to be reset

each time.



3.3 Setting the date and time

Before using the unit, you need to put the LOCK-switch to position "ON" (green).

In "OFF" (red) - position the Bluetooth function is deactivated and all buttons are

locked. i

Press and hold the S-button for at least 3 seconds. i

Firstly, the date figure starts to flash. Press M-button to adjust the actual month.

Press the S-button to confirm the setting. i

Now the day figure starts flashing. Proceed accordingly for the input of day, year,

hour and minute (as described under point 3 and 4). i

On completion of the date and time setting, "Ok" appears on the display. The unit

switches off automatically after about 60 seconds, if no buttons are pressed in order

to save power.







3.4 Setting up the user memory

The MEDISANA Upper arm blood pressure monitor BU 550 connect gives you the

opportunity to assign readings to one of two user memories, each of which provides

500 memory slots. Press and hold the M-button for at least 3 seconds, until the

symbol for User 1 appears in the display. By pressing M-button you can switch

User 1 and User 2 or Guest . If you choose "Guest", the values of the reading will

not be saved. i

Press the S-button to confirm your selection.







3 Getting started

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Medisana BU 550 CONNECT Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Medisana BU 550 CONNECT

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info