Wait 2-3 minutes for the appliance to heat up to the required 4.
temperature before using.
Use the appliance to set your hair as described below.5.
To switch off the appliance, press the ON/OFF button.6.
Always remove plug from the mains socket and allow the appliance 7.
to cool down before cleaning or storage.
Styling tips
First wash your hair and then blowdry until it is almost dry. Brush
your hair using a styling brush. Divide your hair up into small sections
and set them separately piece by piece as described below until the
desired result is achieved. To help separate locks of hair, use clips and
style a small area at a time.
Start with a lock of hair about 5 cm wide, open the clip (2) by 1.
pressing down the handle (3). Position the appliance about halfway
down the lock of hair.
Distribute the hair evenly across the cylinder (1) and close the clip 2.
carefully to trap the hair.
Gently pull the appliance down towards the hair ends. 3.
Make sure that the ends of your hair are trapped securely under 4.
the clip. Then wind the lock of hair around the cylinder up towards
the scalp. Be careful not to allow the hot cylinder to come into
contact with your scalp.
Hold the appliance there for 5-8 seconds, depending on the length 5.
and thickness of your hair. Do not allow the appliance to heat an
area for too long as this can damage your hair.
Open the clip and withdraw the appliance from your hair. 6.
Allow hair to cool before setting.7.
CLEANING
When cleaning the appliance, you should pay attention to the
following:
Remove plug from the mains socket, and allow the appliance to •
cool down before cleaning it.
Never submerge the appliance in water and make sure no water •
enters the appliance.
Clean the appliance by wiping it with a damp cloth. A little •
detergent can be added if the appliance is heavily soiled.
Do not use scouring pads, steel wool or any form of strong •
solvents or abrasive cleaning agents to clean the appliance, as
they may damage the external surfaces of the appliance.
IMPORTANT! Allow to dry completely after cleaning. Do not use •
the appliance if it is damp.
FOR UNITED KINGDOM ONLY
Plug wiring:
This product is fitted with a BS 1363 13-amp plug. If you have
to replace the fuse, only those that are ASTA or BSI approved
to BS1362 and with a rated current of 13 amps should be used.
If there is a fuse cover fitted, this cover must be refitted after
changing the fuse. If the fuse cover is lost or damaged, the plug
must not be used. You must also check if the socket outlets
in your home fit with the plug of the appliance. If the socket
outlet in your home does not fit with the plug, the plug must be
removed and disposed of safely as insertion of the plug into the
socket is likely to cause electric hazard.
As this product is a class II appliance, the pin of BS plug for
earth connection is false.
