2. Insert the bottom end of the body
into the oor nozzle and press it
into place until the body is secure
in the nozzle. See gure 2.
3. Fit the holder by pressing the shaft
down into the foot piece until it
sits securely in place. Insert the
at nozzle (10) and combi-brush
(11) behind the holder’s shaft. See
gure 3.
4. Place the appliance in the holder
to complete assembly. See gure
4.
Figure
1
Figure
2
Figure
3
Figure
4
Battery charging
NOTE! For safety reasons, the
battery is only partially charged when
the appliance leaves the factory.
Therefore, you must always start by
charging the battery fully. Charge
the appliance for 8-9 hours before
rst use. Also, please remember to
recharge the battery of the product
at least 2 times a year to avoid the
battery loosing capacity and to
maintain maximum battery lifetime, if
the appliance is stored not to be used
for a long period.
1. Check that the appliance is
switched off at both on/off buttons
(1 and 3).
2. Place the appliance in the holder
(12).
3. Plug the charger (9) into the mains
socket and connect the cord to
the charger socket on the side of
the holder.
4. Switch on the power. The charging
indicator on the hand-held vacuum
cleaner will start to ash slowly
(once every ve seconds).
5. Allow the battery to charge fully.
Once the battery is fully charged,
the charging indicator will remain
on.
Tips!
We recommend always leaving the
appliance in the holder with the charger
connected when not in use so that the
appliance is always ready to use.
NOTE!
The battery becomes hot during
charging – this is perfectly normal.
USING THE APPLIANCE
This appliance can be used both as
a oor vacuum and as a hand-held
vacuum. Use the oor vacuum to
vacuum oors. Use the hand-held
vacuum cleaner to vacuum difcult-to-
reach spots.
Before using the appliance, check
that the inner lter (5a) and outer lter
(5b) are correctly tted in the dust
container (5c) (see “Emptying the dust
container and cleaning the lters”).
Use as a oor vacuum cleaner
1. Make sure the hand-held vacuum
cleaner (4) has been correctly
tted to the appliance.
2. Fit the oor nozzle (6) by
connecting the end of the body
(7) to the nozzle and pressing the
appliance into place.
Switch on the appliance by
pressing the on/off button (1) on
the handle (2).
3. Press the on/off button again and
release it to turn the appliance off.
