Figure 7 Figure 8
4. The inner and outer lters both
need cleaning. Brush them with a
small brush and/or wash them in
tepid water. Add a little detergent
if necessary. Check that the lters
are COMPLETELY dry before
retting them. NEVER insert a wet
lter into the appliance.
5. Insert the inner lter into the outer
lter and place them in the dust
container. Press the lters down
far enough so that they t tightly
to the sides of the dust container.
The lters can only be tted in one
position.
6. Fit the dust container by pressing
it rmly against the motor until you
hear a click.
7. Replace the hand-held vacuum
cleaner on the appliance.
CLEANING
• Clean the appliance by wiping
it with a damp cloth. A little
detergent can be added if the
appliance is heavily soiled.
• Do not use scouring pads,
steel wool or any form of strong
solvents or abrasive cleaning
agents to clean the appliance,
as they can damage the external
surfaces of the appliance.
• Clean the lters as described
above. Replace the lters with the
same type when worn or when
they can no longer be cleaned
properly.
• Check that the dust container
and the lters are COMPLETELY
dry before re-assembling the
appliance and using it.
Cleaning the brush of the oor
nozzle
There is a rotating brush (13) in the
oor nozzle. The brush must be
cleaned if it becomes covered in hair
or other substances.
1. Switch appliance off.
2. Detach the oor nozzle from the
appliance by pressing the lock
tab at the back of the oor nozzle
connector and sliding off the oor
nozzle.
3. Turn the oor nozzle upside down
so that you can see the rotating
brush.
4. Remove hair, etc. from the brush.
- If necessary, the brush can
be detached by loosening the
screw holding the cover at
the right side of the brush and
removing the cover.
- Detach the brush, clean it and
remount the brush and the
cover.
- Similarly, the castors can be
cleaned by loosening them
with a screwdriver, cleaning
them and remounting them.
IMPORTANT! Check the oor nozzle
and the brush regularly to prevent
delicate ooring becoming scratched.
