Bedienungsanleitung Mercedes S-Class Coupe - 2015 (Seite 314 von 402) (Englisch)

624701

314

Zoom out

Zoom in

Vorherige Seite

1/402

Nächste Seite

When using the integrated garage door

opener, always make sure that nobody is

within the range of movement of the garage

door.

WARNING

Combustion engines emit poisonous exhaust

gases such as carbon monoxide. Inhaling

these exhaust gases leads to poisoning. There

is a risk of fatal injury. Therefore never leave

the engine running in enclosed spaces with-

out sufficient ventilation.

Programming

Programming buttons

Pay attention to the "Important safety notes"

(Y page 311).

Garage door remote control A is not inclu-

ded with the integrated garage door opener.

Turn the SmartKey to position 2 in the igni-

tion lock (Y page 147).

Select one of buttons ; to ? to use to

control the garage door drive.

To start programming mode: press and

hold one of buttons ; to ? on the inte-

grated garage door opener.

The garage door opener is now in program-

ming mode. After a short time, indicator

lamp : lights up yellow.

Indicator lamp : lights up yellow as soon

as button ;, = or ? is programmed for

the first time. If the selected button has

already been programmed, indicator

lamp : will only light up yellow after ten

seconds have elapsed.

Release button ;, = or ?. Indicator

lamp : flashes yellow.

To program the remote control: point

garage door remote control A towards

buttons ; to ? on the rear-view mirror at

a distance of 2 to 8 inches (5 to 20 cm).

Press and hold button B on remote control

A until indicator lamp : lights up green.

When indicator lamp : lights up green:

programming is finished.

When indicator lamp : flashes green: pro-

gramming was successful. The next step is

to synchronize the rolling code

(Y page 312).

Release button B on remote control A for

the garage door drive system.

If indicator lamp : lights up red: repeat the

programing procedure for the correspond-

ing button on the rear-view mirror. When

doing so, vary the distance between remote

control A and the rear-view mirror.

The required distance between remote

control A and the integrated garage door

opener depends on the garage door drive

system. Several attempts might be neces-

sary. You should test every position for at

least 25 seconds before trying another

position.

Synchronizing the rolling code

Pay attention to the "Important safety notes"

(Y page 311).

If the garage door system uses a rolling code,

you will also have to synchronize the garage

door system with the integrated garage door

opener in the rear-view mirror. To do this you

will need to use the programming button on

the door drive control panel. The program-

ming button may be positioned at different

locations depending on the manufacturer. It

is usually located on the door drive unit on the

garage ceiling.

Familiarize yourself with the garage door

drive operating instructions, e.g. under "Pro-

312

Features

Stowage and features

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mercedes S-Class Coupe - 2015 Seite 314

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info