595085
13
Zoom out
Zoom in
Vorherige Seite
1/112
Nächste Seite
ENGLISH
13
ENG
Keep the handles dry, clean and free of oil and
grease.
Caution! The use of other tools and accessories
can result in a risk of injury.
Use the
handle (2) on the magnetic drill stand
when transporting the machine.
Always wear a safety harness when
working on scaffolds.
Wear ear protectors.
Wear protective goggles.
Danger - magnetic field.
Persons with pacemakers prohibited.
4.1 Safety instructions for battery packs:
Protect battery packs from water and
moisture!
Do not expose battery packs to naked
flame!
Do not use faulty or deformed battery packs!
Do not open battery packs!
Do not touch or short-circuit battery packs!
Slightly acidic, flammable fluid may leak
from defective Li-ion battery packs!
If battery fluid leaks out and comes into
contact with your skin, rinse immediately
with plenty of water. If battery fluid leaks
out and comes into contact with your eyes, wash
them with clean water and seek medical attention
immediately.
Remove the battery pack from the machine before
any adjustments, conversions or servicing are
performed.
Before fitting the battery pack, make sure that the
machine is switched off.
See page 3 (please unfold).
1 Magnet block/Magnet
2Handle
3 Supply cock on cooling lubrication unit
4 Container for cooling lubrication unit
5 Threaded pins for adjusting backlash of the
side plate
6 Lock switch to prevent the machine from
moving up/down accidentally
7 Slide plate
8 Switch (switching on/off driving unit)
9 Electronic signal indicator
10 Thumbwheel (1st /2nd gear)
11 Slot in machine neck for driving out tools
12 Removal tool (MK 2) *
13 Drill spindle with tool attachment (MK 2)
14 Anti-twist device
15 Tool holder threaded pins*
16 Tool holder (Weldon, 19 mm) *
17 Quick-action coupling
of the c
ooling lubri-
cation unit
18 Battery pack
19 Two buttons for battery-pack release
20 Button for capacity and signal indicator
21 Capacity and signal indicator
22 Lever for moving driving unit up and down
23 Shaft
24
Display of magnet holding power
25 Ratchet switch lever (activate/deactivate
magnet)
26 Ratchet lever (activate/deactivate magnet)
27 Ratchet on securing strap
28 Securing strap
29 Two holding points
* depending on equipment/not in scope of delivery
Check the machine for possible damage:
Before using the machine, you must carefully
check protective devices or slightly damaged
components to ensure they are operating perfectly
and as intended. Check that moving parts are in
perfect working order and do not jam and check
whether parts are damaged. All parts must be
correctly installed and fulfil all conditions neces-
sary to ensure perfect operation of the grinder.
Damaged protective devices and parts must be
repaired or replaced according to specifications
by an authorised specialist workshop.
6.1 Battery pack
Charge the battery pack before use (18).
If performance diminishes, recharge the battery
pack.
5Overview
6 Initial Operation
17027057_0211 MAG 28 LTX 32.book Seite 13 Dienstag, 1. März 2011 1:15 13
13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Metabo MAG 28 LTX 32 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info