Bedienungsanleitung Microlife BP 3AG1-30 en W (Seite 5 von 43) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch)

536814

Zoom out

Zoom in

Vorherige Seite

1/43

Nächste Seite

3BP 3AG1

Selecting the correct cuff

Microlife offers different cuff sizes. Select the cuff size to match the

circumference of your upper arms (measured by close fitting in the

centre of the upper arm).



Optional preformed cuffs «Easy» are available.



Only use Microlife cuffs.



Contact Microlife Service if the enclosed cuff 6 does not fit.



Connect the cuff to the device by inserting the cuff connector 7

into the cuff socket 3 as far as it will go.

3. Taking a Blood Pressure Measurement using this

Device

Checklist for taking a reliable measurement

1. Avoid activity, eating or smoking immediately before the

measurement.

2. Sit down for at least 5 minutes before the measurement and relax.

3. Always measure on the same arm (normally left).

4. Remove close-fitting garments from the upper arm. To avoid

constriction, shirt sleeves should not be rolled up - they do not

interfere with the cuff if they are laid flat.

5. Always ensure that the correct cuff size is used (marking on the

cuff).

 Fit the cuff closely, but not too tight.

 Make sure that the cuff is positioned 2 cm above the elbow.

 The artery mark located on the cuff (ca. 3 cm long bar) must

lie over the artery which runs down the inner side of the arm.

 Support your arm so it is relaxed.

 Ensure that the cuff is at the same height as your heart.

6. Press the ON/OFF button 1 to start the measurement.

7. The cuff will now pump up automatically. Relax, do not move

and do not tense your arm muscles until the measurement

result is displayed. Breathe normally and do not talk.

8. When the correct pressure is reached, the pumping stops and the

pressure falls gradually. If the required pressure was not reached,

the device will automatically pump some more air into the cuff.

9. During the measurement, the heart symbol AM flashes in the

display and a beep sounds every time a heartbeat is detected.

10.The result, comprising the systolic

and the diastolic

blood

pressure and the pulse

is displayed and a long beep is heard.

Note also the explanations on further displays in this booklet.

11.When the device has finished measuring, remove the cuff.

12.Switch off the device. (The monitor does switch off automatically

after approx.

min.).



You can stop the measurement at any time by pressing the

ON/OFF button (e.g. if you feel uneasy or an unpleasant

pressure sensation).

4. Appearance of the Heart Arrhythmia Indicator for

early Detection

This symbol AL indicates that certain pulse irregularities were

detected during the measurement. In this case, the result may

deviate from your normal blood pressure – repeat the measure-

ment. In most cases, this is no cause for concern. However, if the

symbol appears on a regular basis (e.g. several times a week with

measurements taken daily) we advise you to tell your doctor.

Please show your doctor the following explanation:

5. Data Memory

At the end of each measurement, this device automatically stores

the result.

Viewing the stored values

Press the M-button 8 briefly, when the device is switched off. The

display first shows «M» AO and then a value, e.g. «M 17». This

means that there are 17 values in the memory. The device then

switches to the last stored result.

Pressing the M-button again displays the previous value. Pressing

the M-button repeatedly enables you to move from one stored

value to another.

Cuff size for circumference of upper arm

S 17 - 22 cm (6.75 - 8.75 inches)

M 22 - 32 cm (8.75 - 12.5 inches)

L 32 - 42 cm (12.5 - 16.5 inches)

M - L 22 - 42 cm (8.75 - 16.5 inches)

Information for the doctor on frequent appearance of the

Arrhythmia indicator

This device is an oscillometric blood pressure monitor that also

analyses pulse frequency during measurement. The device is

clinically tested.

The arrhythmia symbol is displayed after the measurement, if pulse

irregularities occur during measurement. If the symbol appears

more frequently (e.g. several times per week on measurements

performed daily) we recommend the patient to seek medical advice.

This device does not replace a cardiac examination, but serves

to detect pulse irregularities at an early stage.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Microlife BP 3AG1-30 en W Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info