Bedienungsanleitung Microlife NC400 (Seite 6 von 93) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Türkisch)

773526

Zoom out

Zoom in

Vorherige Seite

1/93

Nächste Seite

7. Press and hold the START/IO button 7 for 3 seconds

to turn off the device; otherwise the device will automat-

ically switch off after approx. 30 seconds.

NOTE:

Patients and thermometer should stay in similar

room condition for at least 30 minutes.

Don't take a measurement while or immediately after

nursing a baby.



Don't use the thermometer in high humidity environments.

Patients should not drink, eat or exercise before/while

taking the measurement.

Don't move the measurement device from the measu-

ring area before hearing the termination beep.

10 short beeps and a red LCD backlight alert the patient

that he/she may have a temperature equal to or higher

than 37.5 °C.

Always take the temperature in the same location, since

temperature readings may vary according to locations.

Doctors recommend rectal measurement for newborn

infants within the first 6 months, as all other measuring

methods might lead to ambiguous results. If using a non

contact thermometer on those infants, we always recom-

mend verifying the readings with a rectal measurement.

In the following situations it is recommended that three

temperatures are taken with the highest one taken as

the reading:

1. Children under three years of age with a compro-

mised immune system and for whom the presence or

absence of fever is critical.

2. When the user is learning how to use the thermometer

for the first time until he/she has familiarized himself/

herself with the device and obtains consistent readings.

3. If the measurement is surprisingly low.



Readings from different measuring sites should not

be compared as the normal body temperature varies

by measuring site and time of day

, being highest in the

evening and lowest about one hour before waking up.

Normal body temperature ranges:

- Axillar: 34.7 - 37.3 °C / 94.5 - 99.1 °F

- Oral: 35.5 - 37.5 °C / 95.9 - 99.5 °F

- Rectal: 36.6 - 38.0 °C / 97.9 - 100.4 °F

- Microlife NC 400: 35.4 - 37.4 °C / 95.7 - 99.3 °F

8. Changing between Celsius and Fahrenheit

This thermometer can display temperature readings in either

Fahrenheit or Celsius. To switch the display between °C and

°F,

press and hold

the MODE button

for 3 seconds; the

beeper icon is shown on the display. Press the MODE button

again; the current measurement scale («

°C

» or «

°F

» icon)

will be shown on the display

. Change the measurement

scale between °C and °F by pressing the MEMO-button

When the measurement scale has been chosen, press the

START/IO button

to enter the «ready for measuring»

mode; otherwise the device automatically switches to ready

for measuring after 10 seconds

9. How to recall 30 readings in Memory Mode

This thermometer can recall the last 30 readings with a

record of both time and date.

Recall mode AP: Press the MEMO-button 5 to enter

recall mode when the power is off. The memory icon

«M» will flash.

Reading 1 - the last reading AQ: Press and release the

MEMO-button 5 to recall the last reading. Number «1»

and a flashing «M» are displayed.

Pressing and releasing the MEMO-button 5 after the last

30 readings have been recalled will resume the above

sequence from reading 1.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Microlife NC400 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info