Bedienungsanleitung Midea MUED-Serie (Seite 14 von 25) (Englisch)

588088

Zoom out

Zoom in

Vorherige Seite

1/25

Nächste Seite

installation manual

Dissemble the bolts from the cover.(If there isn't a cover on

the outdoor unit, disassemble the bolts from the maintenance

board, and pull it in the direction of the arrow to remove the

protection board.) (Refer to Fig.9-1, Fig.9-2, Fig.9-3)

Connect the connective cables to the terminals as identified

with their respective mached numbers on the terminal block

of indoor and outdoor units.

Re-install the cover or the protection board.

Connect the cable

9.1

The Specification of Power

9.2

Wiring figure

9.3

(Refer to Table9-1～Table 9-15)

(Refer to Fig.9-4～Fig.9-36)

Fig.9-1

Fig.9-2

Protection board

Cover

Protection Board

For detailed installation acceptance please refer to your

power supplier, if restrictions do apply for products like

washing machines, air conditioners or electrical ovens.

For power details of the air conditioner refer to the rating

plate of the product.

For any question contact your local dealer.

Remark per EMC Directive 2004/108/EC.

For to prevent flicker impressions during the start of the

compressor (technical process) ,following installation

conditions do apply.

NOTE

The power connection for the air conditioner has to be

done at the main power distribution. The distribution has

to be of a low impedance, normally the required

impedance reaches at a 32 A fusing point.

No other equipment has to be connected with this power

line.

Split type outdoor unit

Vertical discharge type outdoor unit

All the figures in this manual are for explanation

purpose only. They may be slightly different from the air

conditioner you purchased.The actual unit shall prevail.

NOTE

Fig.9-3

Protection Board

Centrifugal fan outdoor unit

2) The outdoor unit

a. Whether there is vibration or abnormal noise during

operation.

b. Whether the generated wind, noise, or condensed of by

the air conditioner have influenced your neighborhood.

c. Whether any of the refrigerant is leaked.

A protection feature prevents the air conditioner from being

activated for approximately 3 minutes when it is restarted

immediately after shut off.

CAUTION

1) The indoor unit

a. Whether the switch on the remote controller works well.

b. Whether the buttons on the remote controller works

well.

c. Whether the air flow louver moves normally.

d. Whether the room temperature is adjusted well.

e. Whether the indicator lights normally.

f. Whether the temporary buttons works well.

g. Whether the drainage is normal.

h. Whether there is vibration or abnormal noise during

operation.

I. Whether the air conditioner heats well in the case of the

HEATING/COOLING type.

Set the air conditioner under the mode of "COOLING" with

the remote controller, and check the following points. If there

is any malfunction, please resolve it according to the chapter

"Troubleshooting" in the "Owner's Manual".

Test operation

10. TEST OPERATION

The test operation must be carried out after the entire

installation has been completed.

Please confirm the following points before the test operation:

According to the user's requirement, install the remote

controller frame where the remote controller's signal can

reach the indoor unit smoothly.

The power voltage fits the rated voltage of the air

conditioner.

There is no obstacle at the outlet and inlet of the outdoor

and indoor units.

The gas-side and liquid-side stop valves are both opened.

The air conditioner is pre-heated by turning on the power.

The indoor unit and outdoor unit are installed properly.

Tubing and wiring are correctly completed.

The refrigerant pipe system is leakage-checked.

The drainage is unimpeded.

The heating insulation works well.

The ground wiring is connected correctly.

The length of the tubing and the added stow capacity of

the refrigerant have been recorded.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Midea MUED-Serie Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Midea MUED-Serie

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info