Bedienungsanleitung Midland BT NEXT PRO (Seite 34 von 116) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

738682

Zoom out

Zoom in

Vorherige Seite

1/116

Nächste Seite

32 www.midlandeurope.com

Long press the middle button until you hear “FM radio” from the voice announcement.

Now all the three main buttons are dedicated to the FM Radio (See Table C).

Press short the “Forward” or the “Backward” button to seek the FM Radio station.

When you press long the Forward or the Backward button, you can scan up or down the

6 recorded stations. A voice announcement will tell you the number of which memory

you are entering.

To save the station you are listening to, press the Forward and Backward buttons to

gether for 3 sec. You will hear a beep tone for conﬁrmation.

The station is saved over the last recorded station used.

Thanks to the RDS system, the FM Radio will choose the strongest signal available for

the radio station you like to listen. The RDS system is OFF by default, if needed you can

toggle on/o the RDS pressing together the “Volume +” and “Volume –“ buttons for 3

sec when the radio is on. A voice announcement will tell you the RDS status.

How to Disable/Enable the FM Radio

By default the FM radio is on.

Disabling:

› Enter the “Setup” mode: turn o the unit and hold down the “Middle” button about

7 sec., until the Red light is on permanently.

› Press “Middle” and “Volume+” buttons together for 3 seconds. The blue LED will

ﬂash three times.

› Double click on the “Middle” button to exit the “Setup” mode and use the Midland

BTNEXT PRO

Enabling:

› Follow the same procedure up described; now the blue LED will ﬂash once.

To exit the “Setup” mode, double click the “Middle” button.

FM Radio with intercom

When you are in “FM Radio” mode it is not possible to manually open the intercom, you

can only open it using VOX feature (just talk) to the unit paired on the “Middle” button.

To manually activate the intercom you must switch to “Intercom” mode.

FM Radio in background

It is not possible to have the FM radio along with other audio sources. Any active audio

such as Intercom or coming from the VOL+ or VOL- connection, will pause the FM

radio.

Wired audio input

Your Midland BTNEXT PRO can be connected to a wired audio source, like an iPod (or

any other MP3 Player).

Listening to music

To listen to music from the wired input, connect the audio source using the optional

AUX cable. The volume buttons (Vol + and Vol -) can be used to adjust the volume of

the wired audio source (but not independently from the Intercom Volume). The AGC

system will automatically increase the volume on higher speed.

Attention: never set the volume of the MP3 Player to the maximum possible. Normally the

best level is about the 70% of the maximum.

Hint: We recommend that you perform a few tests adjusting the volume of your iPod/MP3

player so at the normal speed the Headset volume is suited to your needs. The AGC system

will automatically increase the volume on higher speed, so you don’t need the VOL+ or

VOL- buttons to adjust it.

C-Radio FM mode

Mode Forward button Middle button Rear button

FM Radio Short press: seek station up

Long press: Scan recorded

Short press: On/o

Long press: Change mode

Short press: seek station up

Long press: Scan recorded

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Midland BT NEXT PRO Seite 34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info