Bedienungsanleitung Morso 3100 series (Seite 12 von 19) (Englisch, Dänisch)

744324

Zoom out

Zoom in

Vorherige Seite

1/19

Nächste Seite

DK ENG

On the oor

National and Local Building Regulations must again be observed when considering the type,

thickness and area of the hearth to be used in the installation. The hearth temperature under

safety test was less than 65°C.

One should of course always make certain that the underlying oor surface can bear the

weight of the stove.

Clearances to Furniture

The clearance requirement from the stove to any furniture should be no less than 800 mm. It

is always necessary to assess whether or not any furniture or other objects situated close-by

can be aected by heat, i.e. dried out.

The distance to any combustible material in front of the stove is minimum 800 mm.

The surface of a wood burning stove gets extremely hot when used and therefore special

attention to safety is paramount, especially where children or the inrm are present.

The stove is equipped with a removable stainless steel handle; for safety reasons it should

be removed during use, especially where children are nearby.

1.5 The chimney

Only if National or Local Regulations permit are you permitted to connect a stove into a chim-

ney that is shared by another appliance. YOU MUST be aware of any applicable Regulations

in this respect.

The wood-burning stove must never been connected to a chimney to which a gas-burning stove

or appliance is connected. An ecient modern stove places heavy demands on the chimney, and

you should have the chimney regularly swept and inspected by your approved chimney sweep.

The cross-sectional area of the chimney (at its narrowest point) must comply with National and

Local Building Regulations. Generally, the area needed for a Morsø wood-burning stove installa-

tion should measure at least 175 cm2 (150 mm diameter). Exceptions to this are: Smoke Exempt

Morsø stoves tted with a 125mm diameter ue collar. These can be connected to a chim-

ney system or liner with a minimal cross sectional area of 123 cm² (125mm diameter)

An over-sized chimney is generally hard to keep warm and results in poor draft. In cases where

there is an oversized masonry chimney, it is recommended that the chimney be lined using an

appropriate chimney lining system with the correct internal diameter. With respect to the chim-

ney termination, all chimneys should terminate in accordance with National and Local Building

Regulations.

Note that National and Local Regulations also apply with regard to the placement of chim-

neys and ues in connection with thatched roofs. See the section on Draft Conditions, 1.9.

The chimney or ue system must be equipped with access doors for inspection and clean-

ing. The size of the cleaning door in the chimney must at least equal to that of the cross-

sectional area of the chimney. In the event that a chimney re occurs resulting from faulty

operation or prolonged use of damp wood fuel, close the air vents completely and contact

your local re department immediately.

1.6 Fluepipe connections

The Stove comes ready prepared to accept an outside air-box kit, for markets where national

or local authorities require it. The outside air-box kit is ordered separately – Product Code:

54362021, detailed tting instructions are included within the kit.

The stove is supplied with a factory tted ue collar (1), this is tted to the top plate. A round

cast iron blanking plate covers the rear ue outlet (behind the rear heat shield). Where a

rear ue installation is required, simply knock out the top steel plate in the rear heat con-

vection panel. This is best done by applying gentle hammer taps immediately onto the small

”bridges” in the circular cut-outs. Once the knock-outs have been removed unbolt the cast

iron blanking plate and install it into the top of the stove. The ue collar can then be bolted

over the rear ue outlet using the bolts and clamps provided.

The cast iron blanking plate can also function as an extra clean-out access whilst perform-

ing the annual cleaning service of the stove and chimney.

Minimum distances from ammable material:

Type of stove Behind the stove

(A)

To the sides of

the stove (B)

Above the

stove

45° corner (C)

Morsø 3112/3116

radiation

200 mm 600 mm 600 mm 600 mm

Morsø 3142

convection with

uninsulated ue

200 mm 400 mm 600 mm 200 mm

Morsø 3142

convection with

insulated ue

50mm 300 mm 600 mm 100 mm

45°

Min. afstand til brandbar hjørnevæg for Morsø 3142

Revisions

Rev.

Sign.:

Title:

Drawing no.:

Dim. without indication of margin acc. to DS/ISO 2768-1 m

1:10

Afstand til hjørnevæg

Distance to Corner wall

Morsø 3142

RSV

06.10.2009

Dimension Skecth

Date of print: 07-10-2016

C:\Users\tol\Documents\TempSWBackupDirectory\AutoRecovery\AutoRecover Of Afstand til hjørnevæg.SLDASM

3100-119 a

Itemno.:

This drawing is Morsø Jernstøberi A/S' property and must not be sold, lended or copied without any written authorization from the company.

Material:

Weight:

Model no.

Drawingtype:

Location of file:

Scale:

Format:

Released:

Construction:

Date:

Side 3 of 6

Min. afstand til brandbar hjørnevæg for Morsø 3142

Revisions

Rev.

Sign.:

Title:

Drawing no.:

Dim. without indication of margin acc. to DS/ISO 2768-1 m

1:10

Afstand til hjørnevæg

Distance to Corner wall

Morsø 3142

RSV

06.10.2009

Dimension Skecth

Date of print: 07-10-2016

C:\Users\tol\Documents\TempSWBackupDirectory\AutoRecovery\AutoRecover Of Afstand til hjørnevæg.SLDASM

3100-119 a

Itemno.:

This drawing is Morsø Jernstøberi A/S' property and must not be sold, lended or copied without any written authorization from the company.

Material:

Weight:

Model no.

Drawingtype:

Location of file:

Scale:

Format:

Released:

Construction:

Date:

Side 2 of 6

Morso 3100 series Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Morso 3100 series

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info