38 Using additional handsets
10. Using additional handsets
Up to 5 handsets can be registered to one base station. Additional handsets must be
registered to the base before you can use them.
• The instructions described below apply specically to the CD3 handset. If you wish to
register another manufacturer’s handset, the instructions may vary. In this case, please
refer to the instruction manual of the additional handset.
• The System PIN is required to register or unregister handsets. The default PIN is 0000.
10.1 Registering an additional handset
NOTE
Handset batteries must be fully charged before you start to register. Hold your handset
close to the base during the registration process. Handsets that were supplied with your
CD3 base are already preregistered.
On the base:
1. Press and hold p until the base emits a double beep. The base will remain in
registration mode for 90 seconds.
On the handset:
1. Press
Menu
, scroll
d
to
Registration
and press
Select
.
2.
Register Handset
is highlighted. Press
Select
.
3. Bases are displayed. If necessary, scroll
u
or
d
to a new base you wish to register the
CD3 handset to and press
Select
.
4. Enter the system PIN and press
OK
.
5. The display shows
Searching Base X
.
6. When registration is successful the display shows
Handset Registered
and you hear a
conrmation beep.
NOTE
If registration is not successful the rst time, please repeat the process again in case the
base registration period ran out of time. If the base is not found after a few seconds, the
handset returns to standby. Try registering again.
If there are already 5 handsets registered to the base, registration will fail. You must de-
register a handset before you can register a new one.
10.2 Register a dierent make of handset to your CD3 base
IMPORTANT
DECT GAP Prole only guarantees that basic calling functions will work correctly between
dierent makes / types of handset and base. There is a possibility that certain features
such as Caller ID will not work correctly.
