Bedienungsanleitung Moulinex Supremia Condensor A AS3 (Seite 16 von 80) (Holländisch)

4751

Zoom out

Zoom in

Vorherige Seite

1/80

Nächste Seite

. models with fixed fryer body: wipe the

inside of the fryer body with a paper kitchen

towel. Then clean the inside with water and

washing-up liquid. Rinse and carefully wipe.

Note: streaks or brown marks may appear

naturally on the inside of the fryer body as a

result of heavy use.

Maintenance

Different parts necessary for the maintenance

of your fryer may be obtained from a Moulinex

approved maintenance centre (see list in the

Moulinex Service booklet)

1. Replacing the seal of the inner cover

- Open the lid

- Remove the lid by gently pushing backwards

and pulling upwards.

- Turn the lid over, take out the fastening

screws, and remove the aluminium inner

cover, as well as the window

- Clean the lid and the window with a damp

sponge and washing-up liquid. Rinse and

wipe.

- Replace the defective seals and put back

the elements together.

2. Replacing the seal of the fryer body

- Remove the defective seal from its support

and replace with a new seal

3. Replacing the timer battery

- Insert a knife edge into the slot situated on

top of the timer display panel, and lever it

forwards.

- Remove the screw situated at the back of

the timer and replace the battery (ref. AG10)

taking care to place the + pointing outward

(the side of the screw). Reassemble.

- The old battery should be given to any

recycling service in operation in your country.

4. Replacing the mains lead

If the mains lead is damaged, requiring

specialist tools, it must be replaced at a

Moulinex approved maintenance centre (see

list in the Moulinex Service booklet). Never

use the fryer if the mains lead is damaged.

What to do if your appliance

does not work

- Firstly check the connection and the mains

lead

- Next, check the following table to find out a

possible cause.

Practical Hints

Problems Causes Solutions

Strong smell You may have Clean the

forgotten to clean

cartridges and

the cartridges drawer

and the «Con-

densor” drawer

Fat or oil has Replace oil or fat

gone bad

The correct fat / Use only high

oil is not quality oil or fat.

being used Do not mix oils

or fats of different

qualities.

Steam escaping Lid is not Close lid

from lid properly shut correctly

The cartridges Put cartridges

have not in freezer

been frozen

Seals are faulty Wipe or replace

seals

Steam escaping Cartridges have Freeze cartrid-

from back of thawed or not ges for at

lid properly frozen least 24 hours

(***)

Recommended Do not fry more

amounts or coo- than recommen-

king time have ded amount

been exceeded

Too many conse- Second set of

cutive frying cartridges

programmes required

Leakage of blue Cartridges no Replace with

liquid longer suitable new set of

for use cartridges

Oil overflowing Fryer is filled Check oil level

above maximum inside

level fryer body

Wet food placed Dry food

in hot oil

Stated quantities Do not fry food

exceeded above weight

indicated

Food not Cooking tempe- Adjust the dial to

browning rature too low the correct

cooking

temperature

Basket over- Do not fry food

loaded above stated

quantities and

weight

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Moulinex Supremia Condensor A AS3 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info