Bedienungsanleitung Movado Watches (Seite 38 von 72) (Englisch)

757301

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

TIME/DATE SETTING

To set the time:

1. Pull crown out to position 2; watch stops.

2. Turn crown in either direction to move hands to

desired time – check that the date changes at

midnight, not at noon.

3. Push crown back in to position 1; watch restarts.

To adjust the date rapidly using crown:

(see Figures A and B)

1. Pull crown out to position 2; watch stops.

2. Turn crown to move hands back and forth between

the hours of 9:00 PM (21H) and just past midnight

(24H); each time the hands hit midnight, the date

will advance by one.

3. When correct date is displayed in window J, push

crown back in to position 1; watch restarts.

To adjust the date rapidly using corrector (select

models only): (see Figure C)

IMPORTANT: DO NOT use the date corrector button

between 8:30 PM (20:30H) and 11:00 PM (23H)

when automatic calendar changes are in progress.

Doing so could damage the movement.

1. Depress date corrector button R, located along

the side of the case at 10 o’clock; each push and

release of button R will advance the date in window

J by one.

CHRONOGRAPH FUNCTIONS

Overview

Use buttons A and B to operate the chronograph.

Pressing button A the ﬁrst time will start the

chronograph. While the chronograph is running,

the three chronograph counter hands will sweep

continuously, indicating the number of currently elapsed

seconds (hand C), minutes up to 30 (hand E), and

hours up to 12 (hand D). Pressing button A a second

time will stop the chronograph. Pressing button B will

reset hands C, E and D to zero.

IMPORTANT: The crown must be in position 1, and

hands must be at zero before the chronograph is

started. If necessary, press button B to reset to zero.

DO NOT use chronograph while crown is pulled out to

position 1.

DO NOT operate chronograph buttons A and B while

timepiece is under water.

NOTE: Hand S is the seconds hand for standard

time-keeping. It is not part of the chronograph function,

and therefore will run continuously while the crown is in

position 1.

Simple chronograph functions:

1. Press button A to start chronograph.

2. Press button A a second time to stop chronograph.

3. Press button B to reset chronograph to zero.

Accumulated time functions:

To measure the combined time of a series of shorter

events, for example the actual playing time of a

football match, where play is repeatedly interrupted:

1. Press button A to start chronograph.

2. Press button A a second time to stop chronograph.

3. Press button A again to resume measurement.

4. Press button A a fourth time to stop chronograph

again.

NOTE: Each time you stop chronograph, chronograph

hands will indicate total accumulated time.

5. Repeat steps 1 and 2 to add each additional

interval of time.

6. After you have taken your ﬁnal accumulated time

reading, press button B to reset chronograph hands

to zero.

16 AUTOMATIC CHRONOGRAPH

1/1 OF A SECOND – TYPE A

Includes original Movado Circa, Movado Master and Vizio automatic chronographs

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Movado Watches Seite 38

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Movado Watches

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info