Bedienungsanleitung Multiplex Razor (Seite 15 von 56) (Deutsch, Englisch, Französisch, Italienisch, Spanisch)

561614

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

Setting the Centre of Gravity

Like any other aircraft, the DogFighter must be balanced at a particular point in order to achieve stable flying

characteristics. Assemble your model ready to fly, and install the flight battery.

The Centre of Gravity (CG) should be at a position 42 mm aft of the wing root leading edge, i.e. at the

fuselage sides. Fig. 6

Mark this point on both sides of the fuselage. You will find it easier to balance this model inverted: support it

at this position on two fingertips, and it should balance level. If not, you can move the flight battery forward

or aft to correct the balance point. Once the exact position is found, mark the location of the flight pack

inside the model to ensure that it is always replaced in the same position.

Flying the RAZZOR

This model is suitable for advanced pilots only!

For the first flight we recommend the following control surface travels:

Ailerons (down / up): - 4 / + 6 mm (Expo: 40%)

Elevator (down / up): - 6 / + 6 mm (Expo: 40%)

Rudder: 25 mm

1. Launching

We recommend hand-launching this model: apply full throttle, and launch the aeroplane directly into wind with

the wings level and the nose pointing up at about 20 – 30°.

2. Flying

For its size and layout the Razzor has extremely good-natured flying characteristics, and it is capable of

smooth, accurate aerobatics at moderate airspeed and faster. Always fly in good, clear conditions, as the

model’s small size can make orientation difficult.

3. Landing

To avoid premature damage to the undercarriage and the whole airframe we recommend that you carry out the

landing approach with the motor running at low speed, then “flare” at the last moment and allow it to “fall” into

tall grass. If your flying field is mown grass, we recommend that you remove the undercarriage and land the

model on its belly.

The aeroplane will only land cleanly on its wheels on an asphalt surface, or on extremely closely mown grass

where the ground is hard and level.

Parts List, RR Razzor

Part No.Pcs. Description Material Dimensions

1 1 Building instructions, RR / RR+

2 1 Complaint form, models

3 1 Fuselage with 2 servos, controller, motor Moulded Elapor foam Ready made

4 1 Tailplane Moulded Elapor foam Ready made

5 1 Wing with 2 servos Moulded Elapor foam Ready made

6 1 Undercarriage Moulded Elapor foam Ready made

7 1 Propeller driver Metal Ready made

8 2 Propeller Plastic Ready made

9 1 Flight battery LiBATT FX-3/1-800 (M6) Ready made

10 2 Wing retainer screw Metal M3

11 2 Wing retainer nut Metal M3

12 1 Fuselage fairing, undercarriage Plastic Ready made

13 1 Aileron Y-lead Plastic Ready made

14 1 Allen key Metal 1.5 mm A/F

15 2 Velcro tape (hook) Plastic Ready made

16 2 Velcro tape (loop) Plastic Ready made

Additional item included with RR+ version:

17 1 Receiver RX-5 M-LINK ID 5, 2.4 GHz Ready made

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Multiplex Razor Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info