Bedienungsanleitung Multiplex Razor (Seite 18 von 56) (Deutsch, Englisch, Französisch, Italienisch, Spanisch)

561614

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

Operating Instructions

MULTIcont BL-15 brushless controller

MULTIPLEX Modellsport GmbH & Co.KG • Westliche Gewerbestraße 1 • D-75015 Bretten • www.multiplex-rc.de Page 3/4

Anleitung MULTIcont BL-15 # 82 5959 (12-04-26/BRAN) • Errors and omissions excepted. •



MULTIPLEX

Select direction of rotation

(triple beep, continuously repeated)

3.1

For reverse rotation

→ stick to full-throttle

position

OR:

For standard rotation*

→ stick to motor OFF

position

⇒ Confirmation signal

emitted

3.2

Stick to centre position

Select motor cut-off type

(quadruple beep, continuously repeated)

4.1

For motor cut

(hard stop)

→ stick to full-

throttle position

OR:

For power

reduction *

→ stick to motor

OFF position

⇒ Confirmation signal emitted

LiPo batteries:

Motor off at 3.0 V / cell

NiXX batteries:

Motor off at 6.0 V!

LiPo batteries:

Motor speed is reduced at 3.2 V /

cell  throttle stick to motor OFF

position  open throttle  motor off

completely at 2.9 V / cell

NiXX batteries:

Motor speed is reduced at 6.0 V 

throttle stick to motor OFF position

 open throttle  motor off

completely at 5.8 V / cell

4.2

Stick to centre

position

Select motor start-up behaviour

(five-times beep, continuously repeated)

5.1

For soft-start *

→ stick to full-throttle

position

OR:

For standard start-up

→ stick to motor OFF

position

⇒ Confirmation signal

emitted

Motor start-up time in

helicopter mode:

approx. 7.0 sec

in fixed-wing mode:

approx. 1.3 sec

Motor start-up time in

helicopter mode:

approx. 2.0 sec

in fixed-wing mode:

approx. 0.2 sec

5.2

Stick to centre position

Select automatic timing

(six-times beep, continuously repeated)

6.1

For automatic timing ON*

→ stick in full-throttle

position

OR:

For automatic timing OFF

→ stick to motor OFF

position

⇒ Confirmation signal

emitted

6.2

Stick to centre position

Select manual timing

→ only if automatic timing was previously set to OFF

(seven-times beep, continuously repeated)

7.1

For “hard” timing

(22 - 30 degrees)

→ stick to full-throttle

position

OR:

For “soft” timing (7 degrees)

→ stick to motor OFF

position

⇒ Confirmation signal

emitted

Recommended for

in-runners

Recommended for

out-runners

7.2

Stick to centre position

Select pulse frequency

(eight-times beep, continuously repeated)

8.1

For 8 kHz pulse frequency

→ stick to full-throttle

position

OR:

For 16 kHz* pulse

frequency

→ stick to motor OFF

position

⇒ Confirmation signal

emitted

8.2

Stick to centre position

Select model type

(nine-times beep, continuously repeated)

9.1

For helicopters (Governor

Mode)

→ stick to full-throttle

position

OR:

For fixed-wing models*

→ stick to motor OFF

position

⇒ Confirmation signal

emitted

Governor mode = constant

rotational speed maintained

In Governor mode the

Brake is automatically

switched OFF, even if you

previously selected Brake

10.

Quitting programming mode

10.1

Stick to centre position

⇒ Rising tone sequence

10.2

Stick to motor OFF position

⇒ Rising tone sequence

sounds twice: the controller

is ready for use, the altered

parameters have been

stored

* Default setting / as supplied

7. BEC = (BATTERY ELIMINATOR CIRCUIT)

MULTIcont BL-15 speed controllers are equipped with a BEC

system: the receiver and servos are fed power from the flight

battery via the regulator; no separate receiver battery is required.

Never connect a separate receiver battery!

Please note that the MULTIcont BL-15 speed controller’s BEC

power supply can only deliver a limited current to the receiving

system in the model:

The actual current drawn by a servo varies according to its

performance, the frequency of commands and – in particular –

the freedom of movement of the control surface linkages (!). This

means that it is essential to measure the current drain of the

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Multiplex Razor Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info