Bedienungsanleitung Multiplex ROYALevo9 (Seite 51 von 58) (Englisch)

30282

Zoom out

Zoom in

Vorherige Seite

1/58

Nächste Seite

Instructions

Seite 51

ENGLISH

16.2.4. Notes on assigning

x PPM 6/7/8/9/12 is set automatically

last servo on channel evo 9 evo 12

6 PPM 6 PPM6

7 PPM 7 PPM 7

8 PPM 8 PPM 8

9 PPM 9 PPM 9

10 to 12 -------- PPM 12

x with PPM 12: Travel 100% , servo norm MPX

If at least one of the channel 10 to 12 is used (servo

assigned), servo travel is limited to 100% and the

norm is set to MPX for all servos.

x In case of problems with older ESCs it may help to

assign a function to servo 9 (even if not used in the

model). This forces the TX to work in PPM 9 mode.

16.3. Sub-menu „Monitor“

The servo monitor acts as a substitute for a receiving

system with servos connected. It enables you check the

function / response of speed controllers, gyro systems,

speed regulators etc., and helps to locate errors.

Two forms of display are available: graphical, with the

output signals displayed in bar graph form, and numeri-

cal, with the signals displayed in % values. You can

switch between the two types of display using the

UP/DOWN (V / W) buttons, or alternatively using one of

the two 3-D digi-adjustors.

16.4. Sub-menu „Test run“

Automatic servo run, which can be used for test pur-

poses and demonstrations, or as an “electronic” aid

when range-checking.

When you select a transmitter control, the software

generates a steadily changing control signal, running

from one end-point of the control to the other. All the

servos operated by this transmitter control (directly or

via a mixer) start running.

You can stop the test run by either of two methods:

x Press the REV/CLR button  „Control

“ appears

x select no control („ - - - - - - - “)

The transit time can be set within 0,1 – 4,0 sec.

17. Main menu „Timer“ A

The ROYALevo has 5 timers. Four of them you will find

in the Timer menu A. The fifth timer records the operat-

ing time of the transmitter, and is only shown in status

display 4.

Oper.time 5.25h

After 1000 hours the timer stops.

17.1. Sub-menu „Model“

I affects active model only

Range = 1000 h (stops at the end)

Press the REV/CLR button to erase

This timer is present once in each model memory, and it

runs constantly when the transmitter is switched on.

The wide range enables you to record the operating

time of any model over an entire season.

17.2. Sub-menu „Slot“

I affects active model only

Alarm range = 3:30:00 (3 ½ hours)

Time range = 4:30:00 (4 ½ hours)

Erase: in menu only

The special feature of this timer is that it is started with

the assigned switch, but cannot be stopped again using

the same switch until the slot time has concluded.

Applications:

x Measuring the total time of a flight

x Slot time in competitions

When you open the sub-menu, you will see the follow-

ing items below the timer name (Slot, Sum or Interval)

and Exit:

Line 1: Time

This is the time which has elapsed since the timer star-

ted. If you select this field, you can erase the time with

the REV/CLR button.

Line 2: Alarm = Slot time

This is where you set and display the slot time.

Line 3: Difference (display only)

This line shows the time which also appears in status

display 3. It is calculated as the difference between Time

and Alarm. The arrow before the difference indicates

the direction in which the indicated time is running:

' counting up

# counting down

Line 4: Switch (display only)

This line shows the switch you are using to control the

timer (<N), and the location of the ON state (' = for-

ward). When the switch is at the selected ON position,

an asterisk '* appears after the arrow.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Multiplex ROYALevo9 Seite 51

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Multiplex ROYALevo9

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info